answersLogoWhite

0


Best Answer

If you are having starting problems replace the starter solenoid switch attached to the short positive battery cable. Well, it could be the starter solenoid, but if you can wiggle the gear shift while turning the key and get it to start, it is definitely the neutral safety switch...oldest electrical gremlin in the book. Climb underneath and look for the linkage between the shifter and the transaxle. Have somebody move the shift (battery negative disconnected of course) to help you identify it. The switch in most front wheel drive vehicles is mounted on the transaxle and is identifiable by at least one electrical wire and the shift linkage as well as being obviously adjustable by loosening a bolt and rotating the switch. Be careful that you don't adjust it so that it will start in any gear except neutral or park. Adjust..test..adjust..test..etc. Jolly good fun.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

12y ago

I'm not quite sure as to when this was posted but I'll go ahead and help out just incase... The brake light switch is located just above the brake pedal. Its a little push button that rest on the top of the brake pedal. Can't miss it, might be kind of hard to get in position to work with your hands and see whats going on down there but its possible. Its all held on by plastic clips, I'm not sure how the grand Cherokee is set up take a look at it to make sure. But if you bought a new one you'll be able to gently break it off... or just push the plastic clips in if you can see and reach them. The button on the switch is pressed in when the brake pedal is stationary, but when you push on the brakes the button is released therefore switching on your brake lights.. hope this helps

This answer is:
User Avatar

User Avatar

Wiki User

13y ago

Most brake light switches ratchet into position and self-adjust. To reset the adjustment, press the brake pedal part way down & pull the switch out toward the pedal until it clicks several times.

This answer is:
User Avatar

User Avatar

Wiki User

10y ago

You can change brake light switches on a Seat Toledo by first making sure that the engine of the vehicle is turned of. Then you can replace the old brake light.

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

underneath the glove compartment

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the brake light switch on a renault laguna?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the brake light switch on a Renault laguna?

under the engine beside the paseneger wheel, blue connector


Anyone know why your brake lights are not working on Renault Laguna 1999 the fuse is fine and the rear window brake light is ok. also the reverse lights are ok too?

Check the brake light switch.


What brake fluid for a 1998 Renault laguna?

The specification is DOT4. You can use any manufacturer, but is strongly advised to replace all liquid, to wash the sistem with new brand liquid. Normally, Renault recommend Elf products.


Why won't Renault megane brake lights work It's not the 3no. bulbs and it's not the fuses?

The probable cause of the brake lights not working on your Renault is the brake light switch. The brake light switch can be found under the dashboard by the foot pedal.


How do you replace the Brake Light Switch in a 2000 ZX2?

how to replace the brake light switch at the pedal of a 2001 ford zx2


How do you replace the brake switch on a 1990 Maxima?

look on the brake pedal you will see a lil switch there that's the brake light switch


Where is the manual override for electric parking brake on a 56 Renault laguna?

under the centre console , lift the lid and take the bottom out, it is under there.


Renault espace 1996 the brake light have stopped working the fuse and blubs have been checked what else can i do?

try the switch on the brake pedal maybe try the switch on the brake pedal maybe


How do you replace the stop light switch in a 1998 chrysler Concorde?

brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace


How do you change the Brake pedal switch on a Honda Accord EX?

The brake pedal switch is bad. How do I replace it?


How do you replace the brake light switch on a 99 Chevy Blazer?

you can find the switch on the back of the brake pedal.


How do you replace a brake light switch on a dodge neon?

The brake light switch, on a Dodge neon, can be found under the dashboard just below the steering column. The brake light switch just unplugs. Unplug the switch and replace with a new one.