Diagnostic Trouble Code (DTC) P1309 indicates Misfire Detection Monitor is not enabled. Breakout box installed, PCM disconnected. Connect digital multimeter between PCM test pin 85 and test pins 51 or 103. Bump engine in short burst with the starter without starting engine for at least 10 engine revolutions. Answer this question: Does digital multimeter reading switch between low (less than 2.0 volts DC) and high (greater than 8.0 volts DC)? If Yes, Verify correct installation by referring to the Powertrain/Engine Group in the Workshop Manual. If the CMP is installed properly, REPLACE PCM. RESTORE vehicle. RERUN Quick Test. If no, REPLACE CMP sensor. RESTORE vehicle. COMPLETE Misfire Monitor Repair Verification Drive Cycle. RERUN Quick Test.
Trouble code P1309 means: Misfire Monitor Hardware - CMP Misaligned, CKP/CMP Noise, PCM AICE Chip
P1309 Misfire Monitor Disabled
are there two adjustment screws on the headlights on a 1998 ford taurus
what will cause a Ford Taurus 1998 24 valve to overheat
20 city 30 highway for the 1998 Ford Taurus se
According to the 1998 Ford Taurus Owner Guide ( 5W-30 )
Ford Taurus
yes it will no complications.
On a 1998 Ford Taurus : ( 60.6 litres / 16.0 U.S. gallons )
According to the 1998 Ford Taurus Owner Guide ( 5W-30 )
Trouble code P0411 means: Secondary Air Injection Incorrect Upstream Flow Detected
For a 1998 Ford Taurus : ( the gas tank capacity is 16 U.S. gallons )