You can not glue brass directly to PVC pipe. Use male/female adapters to join these two materials. ie, a male threaded PVC end fitting glued to the PVC pipe and a female threaded brass fitting screwed onto that.
You use one of the PVC adhesives. I use Weld-On 711 most, but also Oatey 636 Transition Cement for joining different pipes and Weld-On 725 for joining PVC underwater.
its glue spicily for pvc pipe only
I don't understand why you'd want to do that . CPVC glue is expensive, PVC glue is cheap and glues PVC pipe better.
if your waste pipe is PVC and your glue is for PVC . yes! but make sure to use a primer(cleaner) on the pipe first.
with PVC glue
Remove the trap and clean it out. If it is all PVC and glue jointed, cut the pipe above and below the trap, clean it out and glue it back together with couplings.
NO, PVC is very sensitive to which glue is used. In Domestic pipe applications you should use Weld-On 711
No, they cannot be connected. There is no glue on the market at the present time that can glue PVC & ABS together. It's difficult, as after one tries to glue it it gives the impression of being solid, but under pressure it will fail. Also, keep in mind that some plumbing codes do not allow ABS pipe to be used.
Abs to PVC glue sold at home depot Color it aqua blue/green plumbers key term. GUMBY GLUE Depends upon what you mean by "black pipe". If you mean ABS drain pipe, there is glue for that. If you mean steel "black pipe", i.e., non-galvanized, then you would need a threaded connection adapted to the PVC (either a female PVC connector on a male black pipe or a male PVC connector into a female black pipe fitting). The secondary question would be, "Why would anyone want do to that?"
ABS yellow glue is the correct glue for ABS pipe. The only other glue to consider is Weld On Transition cement if you are gluing ABS to PVC parts.
Yes and NO depending on what kind of piping system. for drain connections yes like tub drains or fixture traps but you need access to all slip/compression fittings. and NO you can not use PVC to brass for like a discharge pipe on a waterheater PRV (pressure relief valve) or any hot water piping system
A PVC pipe glue will take at least 4 hours to dry. 12 hours before putting water pressure in it.
Yes, you can. You need PVC glue though - 711 is best