If your battery is completely dead, or battery disconnected. The key, once in and turned would not come out for me. Once I charged up the battery I Was able to remove the key. You can also remove the small plug in the underside of the steering column. May not be a plug but just a circle so I used a small drill bit right in the middle of it. Very tough to see as there is only a small faint circle visible. Once removed it will expose a pin. i usually work blind and just push the small scew driver in the hole. Push the pin then the key will turn back to the full off position and can be removed.
how to remove key stuck in ignition switch in Chevy colbalt
remove battery cable
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
If the key is stuck in your 1998 Mazda 626, the steering wheel column may be locked. To remove the key, adjust the steering wheel and turn it clockwise to the proper position. Then try removing the key.
is it a ford? push the key in further and then turn it
There should be a lock on the ignition a push button that you push and turn to remove the key
...just unstick-it!
Try to put your car on the parking breakes.
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
i have no clue i have the same problem with my Mazda 1999 626