There is a screw located in the side of the door above where the locking component is and there is another one under the middle cover in the handle This holds the whole handle assembly in place. Remove these screws (it should be a large Philips head and a small one at the front part) and try removing the handle. removal of the door panel is not necessary no rods connect it to the inner handle and stuff.
Remove the inspection plug in the door jamb-a posidrive screw holds the stationary part of the handle-remove-pull the swing (pivot) and slide towards the rear of the car and the handle will slide out.
To replace the door handle on a 1968 Beetle, the inside door panel needs to be removed. First, remove any light lenses in the door, then remove the clips on the sides and corners. The old door handle can be removed by loosening the screws on the inside. Then, position the new door handle and tighten the screws. Replace the door panel by popping it back into place.
The door handle on a VW Jetta is repaired by removing the door trim, disconnecting the door release, and unbolting the handle. A new handle can then be put in place and bolted in.
get a person who know how to do it
The 2007 Volkswagen Passat has 16 valves.
The 2007 Volkswagen Passat is a gas-powered vehicle.
The 2007 Volkswagen Passat has an inline 4 engine.
The 2007 Volkswagen Passat has a 6-speed manual.
The 2007 Volkswagen Passat has double overhead cam (DOHC).
The 2007 Volkswagen Passat has a drag coefficient of 0.28 Cd.
The 2007 Volkswagen Passat is 15 ft. 8.2 in. (188.2 in.) long.
The curb weight of the 2007 Volkswagen Passat is 3305 lbs..
The 2007 Volkswagen Passat's turning circle is 35.8 ft..
The height of the 2007 Volkswagen Passat is 4 ft. 10 in. (58 in.).
The 2007 Volkswagen Passat has 54.6 in. of rear shoulder room.