0
Your 89 New Yorker has a peice of trim at the bottom the tail light, in that small piece of trim is a screw. Take that screw out and you can get to the rest of the screws that hold the tail light assembly in place, Oh yes most important you must have the trunk lid raised so you can get to the wiring harness.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What needs to be removed to replace a 1989 Chrysler New Yorker Heater Core?
The entire dash and the HVAC housing.
How do you adjust valves on 1989 Chrysler new yorker?
The valves on all engines in a 1989 Chrysler New Yorker are not adjustable. The hydraulic lifters are self adjusting.
Do you have to pull the harmonic balance to replace the water pump on a 1989 Chrysler new yorker?
On the 3.0L, yes.On the 3.0L, yes.
What kind of oil does a 1989 chrysler new yorker take?
10w3010w30
I have a 1989 Chrysler New Yorker that was working great then I tried to start it and it turns over and runs for about a second and quits. What can you do?
check your distributor,you may need to replace
Why won't your 1989 Chrysler new yorker engage out of first gear?
Transmission in need of SERVICE.
Where is the Fuel pressure regulator on 1989 Chrysler new yorker?
It is part of the pump module in the tank.
Where are the freeze plugs located on a 1989 Chrysler new yorker?
They are on both sides as well as the rear.
Where is the fuel pump reset switch on a Chrysler new yorker 1989?
It doesn't have one. Chrysler uses relays to controll the fuel system.
What type of coolant does 1989 Chrysler new yorker use?
It uses regular old green antifreeze.
Where is the thermostat on a 1989 Chrysler new yorker?
It is under the housing where the upper radiator hose attaches to the engine.
Where is the blower motor on a 1989 Chrysler New Yorker?
It is inside the HVAC housing behind the glove box.
