If this is a single overhead cam, possibly A15SMS (engine type):
If you have everything stripped down and can see the crank shaft gear, you will notice an arrow stamped into one of the gear teeth.
this arrow must point towards the bottom, you will notice a mark (notch) cut into the housing, line the arrow on the gear with this notch. remove the four 10mm bolts that secure the top cover of the timing belt, gently open the cover (not removing it) to see the Cam Gear. You will not be able to remove the cover because of the design.
The Cam Gear should have a line stamped into one of its teeth, this should be pointing up and towards the top. On the inner cover you will notice a notch in the casing, line both up together if it is not already. You can check the following if unsure:
Remove # 1 spark plug (nearest the Cam Belt) and place a long screwdriver in the hole carefully to feel the piston is at the top, #2 and 3 will be down and the last one #4 at the distributor end will also be up. Remove the rocker cover and you should see the Cam loabes on #1 piston free, (no pressure on the cam shaft) meaning the valves are closed.
How much oil a Daewoo Lanos SE 1998 is used to change the oil in the motor
.044
the firing order is 1342 on a daeoo lanos 1998
where are the timing chain marks
two 1 upstream in the exhaust manifold 2 after cat converter
Timing marks are on the sprockets and on the timing belt itself. No other marks are necessary.
What is the timing marks for a 1998 350 Big Bear 4x4
1998 and newer have no timing marks. Timing cannot be adjusted.
there is no timing marks
There should be advance marks on the harmonic balancer, and timing marks on both timing chain gears.
Your 1998 Mazda 3.1 liter engine does not have timing marks on the crankshaft. The timing marks are on the engine flywheel.
1.5 single cam is free running 1.6 twin cam is not