I am not an electrical guy....but since this question was left unanswered....i'll just put in some nonsense!!
For AC Load: VxIxPF (V=VoltageRequired, I=Current Required, PF=Power Factor) The Power Factor is normally considered to be 0.8 as a thumb rule.
For DC Load: VxI, here the power factor is consisdered to be 1, since it is a DC current
!!
Byeee!
yes
The term 'burden' is used to describe the secondary load applied to an instrument transformer; the reason for this is so that it is not confused with the 'load' supplied by the high-voltage circuit to which the transformer's primary is connected. A burden is either a measuring instruments (ammeter,voltmeter, wattmeter, etc.) or protective relay, depending on the function of the instrument transformer. 'V.A' is the symbol for 'volt ampere', which defines the 'power' rating of the instrument transformer.
Electrical voltage can be changed by a transformer.
stress is the ratio between the load and area
Electrical wire size is directly dependant on the load amperage that is connected to it. The higher the load amperage, the larger the cross sectional area of the wire needs to be. The connected amperage to a conductor is determined by a group of electrical experts and their results are then written into the latest addition of the electrical code book of the country in which you live.
yes
An ammeter is an instrument that measures electrical current as it travels through a conduit. Amperes are what the measurements that are are measured aree called.
Load is simply any thing which dissipate electrical energy.
A load increases the flow of electrical current in a series circuit. No load, no flow.
What instrument do we use to measure the electrical and mechanical vibrations
Rheostat is the name of an instrument used to vary electrical resistance.
Yes, you can run electrical wires in a load bearing wall.
Anything device can transform electrical energy into other form of energy. This is called an electrical load.
No it is not considered a load. A load transforms electrical energy into other types of energy :)
The term 'burden' is used to describe the secondary load applied to an instrument transformer; the reason for this is so that it is not confused with the 'load' supplied by the high-voltage circuit to which the transformer's primary is connected. A burden is either a measuring instruments (ammeter,voltmeter, wattmeter, etc.) or protective relay, depending on the function of the instrument transformer. 'V.A' is the symbol for 'volt ampere', which defines the 'power' rating of the instrument transformer.
SMALL
a nonlinear electrical load, like a battery charger or water heater when present in a power system produces harmonics or rather distortions which leads to improper proportionality of voltage to current. so that's an electrical load