It will not work at all.
no
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
No, the voltage of 500 volts is too high to operate a 380 volt motor.
It will probably run but not correctly. Low voltage will cause the motor to draw less amps than it's designed to. It will not reach its rated RPMs and such slow operation may shorten its operating life.
no
100
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
Generally this will be possible. To keep the motor energized correctly you need to keep the volts per hertz roughly at nameplate (so 7.6 volts per 1 Hz). 460/60 = 7.66 volts per hert. I would still verify with the motor manufacturer that it is OK to use in the fashion you are planning, though.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
I know that a company named TEMco makes a 380v to 120/208 transformer. You can try contacting them for your specific application I will attach their website for you.
It is an extremely expensive way of utilizing the deep fat fryer. You should look into changing the heating coils in the fryer to utilize the new voltage. That said it can be done.
Yes, But in this case the current will rise up by about 15% at full load. So if you will use the motor to drive any mechanical load take in your consideration the mechanical load Power (KW) must not exceed 85% of motor power (KW)
Should work at nearly full power as long as the polarities of the 4 pin plug are in sync and it is a 3 phase 50Hz motor. Do a regular temperature check under full operating conditions for the first hour to ensure speed is enough for cooling.
Depending on the type (three phase, single phase), there are generic power factor and efficiency values you can estimate if you haven't chosen a specific motor, but need to size wiring ahead of time. You'll need to double check after the motor is specified, though. Cart before the horse. You can find these values by simply comparing a half dozen motors similar to what you're thinking (compare phase, horsepower/kw rating, duty factor, etc.).