1. Open the hood; locate two angled metal sticks just above the headlight system. They are clipped in towards the engine; turn them 45 degrees towards the front of the vehicle and lift out. Place them to the side for a few minutes.
2. Then jiggle the headlight assembly to the right/left and one of inner side should start to come out. Then the rest of the piece will come out. BE CAREFUL; you can scratch paint if you are too rough.
3. Disconnect the bulb assemblies by squeezing the little lip and then turning the bulb assembly. Replace as necessary.
4. IMPORTANT: When you have this out, go ahead and pull the lower assembly out too; this is where your daytime running lights as well as the turn signal lights are. Make sure these are replaced too; they are cheap and good to replace all at the same time.
5. The lower assembly has a grey plastic clip on the back of the assemly; to the far left/right of the unit. Pop this and then the whole thing will come forward.
Reassemble in the reverse order; when you get the headlight assembly in place; the pins will drop in and snap back into place.
You will need to take the complete headlight assembly loose or out to get to the bulb to change it.
I went to Auto Zone, they will install it after you purchase it.
Come to our enthusiasts forum and find out www.trailvoy.com
6 Qts. with new filter.
mmcda
The full fuel tank capacity on a 2005 Chevy Suburban is 31 gallons. It averages 16 mpg.
mmcda
Take it to the dealer.
Open the hood and then examine the top of the headlight assembly and locate the two pins that can be pulled up and out of the assembly. Then rotate the headlight Assembly out of the front of the grille and change the headlight bulb...reverse the process
$1,300
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
0.060