0
It should as far as both hubs are designed for the same model, for instance, both should be GT, or GS and so on.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
1999 Mitsubishi eclipse GST How do you remove front drive shafts from hub when they are stuck?
Buy a new hub
How do you change the front wheel bearings on a 2001 Mitsubishi Mirage?
The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage
Where is the wheel hub assembly on a Mitsubishi Galant?
Behind the wheel?
When did Hub Kittle die?
Hub Kittle died in 2004.
When was The Hub Weekly created?
The Hub Weekly was created in 2004.
How do you change the front wheel bearings on a 2001 Mitsubishi Montero Limited?
You cannot. You have to buy the whole assembly that includes the wheel hub. the bearings are inside and are lubed for life. When they fail, they are inside the hub to protect your other front end parts and also keeps your wheel from coming off!!!
When did Hub Bechtol die?
Hub Bechtol died on 2004-10-22.
When was Sengkang Community Hub created?
Sengkang Community Hub was created in 2004.
What size is the nut on a 2001 Ford Escape front hub?
what size is the nut holding the front hub on a 2001 ford escape
How to replace a wheel bearing in a 1994 Mitsubishi Eclipses?
Just get a new hub from a junkyard.
How do you remove the plastic hub cap on a 2001 Mitsubishi Mirage ES?
there is two ways to remove to hubs. the first is brut strength, pry at it with a flat hub bar or screwdriver. the other way is, look at the hub u will see a wire running around the hub, there is a spot on the hub that is flared where the hub meets the rim nearest the tire. find this spot put a wide flat screwdriver or hub bar in till it is past the hard wire running throught the rim and pry till it gives. then move around the rim and pry till the hub pops off
How do you pull rear brake hub on 2004 outlander Mitsubishi?
there are two holes on the rear brake hub. Find the correct size bolt and screw them in the holes. Screw one then the other till it pops...then slide it off. there are two holes on the rear brake hub. Find the correct size bolt and screw them in the holes. Screw one then the other till it pops...then slide it off.
