they are located on the verey back wall of all hatch back if u cant see them u may have to get them fitted
at the front of the boot x
i think its 32 for the front and 34 for the back. That's on a front wheel drive 3 door hatch
get all wheels balanced
I had trouble finding a manual but rang around to some book stores and found one in NSW which ordered one for me from the UK. The Nissan Almera is the UK name for the Pulsar. Same car. Here's the link for the Nissan Pulsar 02 manual which I bought (My car is the hatch which was built in the UK anyway). http://www.haynes.co.uk/webapp/wcs/stores/servlet/ProductDisplay?catalogId=10001&storeId=10001&productId=44253&langId=-1 I do not know the name of the bookstore who ordered it for me as I've lost the receipt. Wish I did though... they were so helpful!!
How to replace a brake light on a nissan Tiida hatch back.
4x4? coupe? sedan? hatch?
Yes. It is a direct fit. Nissan didn't change the rear hatch and they are interchangeable. 1984-86 won't have the third brake light. 1987-1989 will and you'll have to wire that in if you want it to be operable.
in the floor of the trunk or hatch
I have an 07 and the glass hatch opener is to the right of the rear hatch opener. It is much smaller though.
if your talking about the rear hatch i just took a flat head screwdriver and popped the little rings off around the connector where in attaches to the car and the hatch
Open the rear tail gate. Directly under the boot 'lip' there is a preinstalled restraint. It is right under the lip, where the latch is. There are also 2 points, 1 either side of the boot floor, however no restraint has been fitted. You have to remove the black gromet, then install the anchor and bolt.
i bought new horn for my nissan almera 5 door hatch back 1500cc and still wont work and checked fuse