0
If you're connecting 3-inch copper pipe to 3-inch PVC with a rubber sleeve and they meet on a parallel horizontal plane and need a slight angle so the PVC can slope downward how do you get the angle?
Wiki User
∙ 12y ago
0
Mason Ernser
Wiki User
∙ 12y agoThis should not even be a problem unless the angle is more than slight. Connect the two together and drop the PVC or put a PVC elbow in there .somewhere/
Add your answer:
Earn +20 pts
What is the difference between vertical and horizontal cabling?
Vertical Cabling - Runs between floor to floor. It is used for Core to Distribution (or Access) switch connectivity. Usually consists of fiber cables Horizontal Cabling - Runs on one floor. Runs from Distribution or Access switches to the end user. Usually copper.
Is the copper wire positive or negative?
copper is positive
Is a is quarter made of copper?
Mostly. The core is 100% copper and the outer cladding is 75% copper + 25% nickel. Taken together that makes the coin about 83% copper overall.
The copper cube had a mass of 2.7g and the volume of the copper cube is 1cm to the 3rd power?
this means that copper is 2.7g/cm3
How many percent of copper percent in brass?
there are many combinations of brass/copper/zinc. High brass for example has 65% copper and 35% zinc. Nickel brass has 70% copper and 24.5% zinc with 5.5% nickel Prince's has 75% copper and 25% zinc
Why Connecting wires made of copper?
Copper is great for conducting electricity, is malable, and has a high melting point.
What element is copper?
Periods are the horizontal rows on the Periodic Table. Cu is in the 4th row. Therefore, copper is in period 4 on the Periodic Table.
What is the element copper?
Periods are the horizontal rows on the Periodic Table. Cu is in the 4th row. Therefore, copper is in period 4 on the periodic table.
Why is it advised to clean the ends of connecting wires before connecting them?
because electricity flows very nicely through copper but not so well through dirt.
Which forces act mostly in a horizontal direction?
The acceleration of a automobile will be in a horizontal direction.
Do you use anything like rectorseal when connecting CPVC to copper?
Rectorseal is for gas. Use Megalock.
Why are copper wires used as the connecting wires?
Copper is a metal and as such it can conduct electricity very well. Additionally, copper is a very good conductor off heat when compared to the more abundant metals such as aluminium.
When connecting PVC to copper with the help of a rubber sleeve should there be a gap between the 2 pipes or should you place the PVC inside the copper and tighten the gaskets?
If you are connecting water piping (DO NOT USE THAT METHOD) call plumber. Or go to Lowe's and ask someone what fittings you would need.
What is the wire size needed to feed a 400 amp service with parallel copper?
It depends on the length of the run
A piece of copper wire was cut into n equal parts these parts are connected in parallel how will the resistance of the parallel combination compare with the resistance of the wire?
The resulting resistance of the parallel combination will be the resistance of the original wire divided by n squared.
Excessive copper in the engine oil?
The big-end shells (connecting rod to crankshaft) and crank shaft journal bearings have failed.
What materials will you need to make a parallel circuit?
Lightbulb(load),Battery(Power source),Switch,Copper wire
