answersLogoWhite

0


Best Answer

Is this an automatic tranny? If so, an incorrect fluid type may have been put into the trans after replacing the axles causing a shudder.

Check all motor/trans mounts.It needs a front end alignment, you move the setting when youchenged the cvjoints.

answercvs should not make car shudder on acceleration i would try wheel alignment, and check drive shaft U-joints

Poor or low quality axles - like you might buy at Checker or O'Reiley can sometimes cause this sort of shudder or vibration. I have never had this issue when using OEM parts, however they are much more costly.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If you replaced both cv's and now the car shudders on acceleration then replaced both again and still same thing what could be the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What could be wrong if a 1996 Buick LeSabre starts and drives then will not start again?

I had the same problem with a 1992 Park Avenue with the 3800 engine. I first replaced the electronic ignition but that did not fix the problem. I then replaced the crankshaft heat sensor. That fixed my problem.


With a 1994 Dodge Spirit why would the car make a thumping noise decelerating from 35 MPH or when beginning acceleration Sounds like its from the hood but could be the wheels?

you might want to check your motor mounts...I had one gone ..had it replaced...month later gone again...Now I had it replaced again and havent had any problems.


How do you make old and dull vinyl shudders look new again?

A person can make old and dull vinyl shades new again by spraying them with furniture polish. This will remove the dust from the shades and allow them to shine.


Has anyone had problem with Suzuki 2003 areio hatchback latch?

I replaced the lock on my 2003 Suzuki Areio hatchback and now I find it is starting to stick again, I was wondering if this is a common problem with this model?


Your 2001 sebring makes a humming noise coming from your filter Had it replaced about a month ago Now it is making that noise again What is the problem?

its probably your radiator


Head gasket repair on a 2002 impala?

I replaced mine at 100kmiles. I hear its a common problem. Think I paid about $500. I bet it goes out again.


Why does your Es300 Lexus sometime start and sometime hard to start?

I had the same problem before. All I hear is a click when I try to turn the ignition on. I just replaced the starter motor and never had that problem again.


Is it true or false that renewable resources can be replaced or grown again?

True. Renewable resources can be replaced or grown again.


What can be the problem if my car's heater only outputs lukewarm air?

It can be the heating block, which only needs to be replaced before you start getting warm air again.


Why does the power steering hose frequently blow off the fitting on the gearbox -especially in cold weather-replaced the pump-94 T-bird-4.6L?

If you replaced the hose and it happened again, it's probably an over-pressure condition. If you HAVEN'T replaced the hose, try it. I had this exact problem. I put a screw type clamp on it instead of the spring type. took care of that problem..


Did Axle get replaced in inazuma 11?

yas he did get replaced but came back again


1988 Monte Carlo ss stalls at when a stop?

I have an 88 ss that had the same problem. I replaced the distributor cap and it ran like new again. hope this helps