Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Ford > Is a ford 300 straight six a good engine to mount with a ford c6 transmission?

Is a ford 300 straight six a good engine to mount with a ford c6 transmission?

In: Ford, Ford Bronco [Edit categories]

Answer:

The 300 cubic inch 6 cylinder is a great engine and IMO one of the best truck engines ever built. It has tons of torque and was best suited for a truck application where pulling power was needed. It does not have lots of horsepower but has more torque than a 302 V8. Click the link for more information.

Contributor:

Clay

First answer by Clay. Last edit by Clay. Contributor trust: 4947 [recommend contributor ]. Question popularity: 1 [recommend question].

[report abuse]

Sources and related links: [Edit]

Ford 300 Inline 6

Can you answer these Ford questions?

	What is the worst car?	Answer it!
	Who made the Ford Heritage RV?	Answer it!
	If a Ford Puma headlamp levelling motor is not working is it likely to be a problem with the electrics or the motor itself?	Answer it!
	How do you do your own major tune up for a Ford Windstar?	Answer it!
	What is the Ford Motor Company Foundation Mission?	Answer it!

Relevant answers:

Is a ford 390 a good engine?
Yes, it it s very solid dependable engine but is a gas hog.
Will a Ford Ranger transmission fit a Ford Escort engine?
Since the Escort platform is FWD (front wheel drive) anf the Ranger platform is RWD (rear wheel drive) there is no similarity in the transmissions. In other words, no... actually the above answer is...
Will a C6 transmission fit a 390 ford engine?
Depends on the C6 transmission you have. They made several variants for different Ford Engine types for the FE and 385 Big Blocks. So For a 390 you will need a C6 that mates to an FE engine.
How do you remove a transmission from a ford F150 300 six?
first you remove the shift linkage, and all wires and lines going to and from the trans. Then you remove the drive shaft. You do this by loosing the u bolts that hold the drive shat to the rear end....