Line is the left hole of an outlet. Neutral is the right, and ground is the upside-down semicircle. A live wire is a wire with current flowing through it. Because neutral doesn't have any current in it, but line does, you could say that line is live. This explains why that you can be shocked from touching just the line. You can't be by touching just the neutral or ground. Line to neutral is the most deadliest if it travels across you. Line to ground will tingle a lot, but it won't necessarily kill you because the current draw isn't nearly as much as line to neutral. But basically line is the most dangerous part of an outlet, so line or live, both are dangerous. :P Female Electricity Geeks will rule the world. Does this question matter? We will all die anyways XD but yeah. That's the gist of it.
The common wire in a 120 vac system would be the neutral, the term line is used for incoming power to a device. Line can be made of two ungrounded conductors (hots) or one ungrounded conductor and one grounded conductor(neutral). Sometimes two or three ungrounded conductors (hots) and a neutral may make up the incoming "line" as in a three phase service. You will see the designation on some equipment at terminal strips for incoming line as L1 and L2. L2 usually being the neutral terminal.
In electrical terms the common wire is the neutral or the wire that returns from the circuit load, so no the common wire is not the same as the line wire.
You connect the fuse to the live wire as it is the one with the potential difference of 220V and in case of short circuit current will blow out here
If you are referring to a high-voltage line, then it will be a three-phase system, where each of the three conductors is live.
If you live in Europe, then the brown wire is the line ('hot') conductor; a blue wire is the neutral conductor, and a yellow/green striped wire is the protective (earth) conductor.
The Line normally refers to the live wire in a single-phase system and the three live wire of a 3-phase system. In a 3-phase system the line voltage is usually quoted as the nominal voltage, and that is the voltage between any two of the live wires. The voltage between one of the lines and neutral is 1/sqrt(3) times less.
A 'live' or 'hot' wire is a wire that is connected to a power source. This wire supplies voltage to a load ( light bulb, hair dryer, etc.). When the load is also connected a neutral or another live wire this becomes a path for the flow of current (amps) known as a circuit.
You connect the fuse to the live wire as it is the one with the potential difference of 220V and in case of short circuit current will blow out here
You can use a wire tester to determine if a wire is live. You can also touch the positive wire on the ground wire, if the wire produces a spark it is live.
If you are referring to a high-voltage line, then it will be a three-phase system, where each of the three conductors is live.
If you live in Europe, then the brown wire is the line ('hot') conductor; a blue wire is the neutral conductor, and a yellow/green striped wire is the protective (earth) conductor.
If a switch was on the neutral wire the live wire would still be at the mains potential even when the switch was off. This would cause on en electric shock when one handles any conductor linked to the live wire
The line wire will be hot and carrying power when the breaker is on. The load wire will not be hot and will have no voltage on it until it is connected with the line wire.
A metal rope is also called a wire rope.
Line, phase, neutral are terms used to describe the conductors in a three-phase system. The three live wires are called 'lines', and less correctly, 'phases'. Neutral is used for the fourth wire which in a balanced system carries no current.
A 'live' or 'hot' wire is a wire that is connected to a power source. This wire supplies voltage to a load ( light bulb, hair dryer, etc.). When the load is also connected a neutral or another live wire this becomes a path for the flow of current (amps) known as a circuit.
The Line normally refers to the live wire in a single-phase system and the three live wire of a 3-phase system. In a 3-phase system the line voltage is usually quoted as the nominal voltage, and that is the voltage between any two of the live wires. The voltage between one of the lines and neutral is 1/sqrt(3) times less.
The Line normally refers to the live wire in a single-phase system and the three live wire of a 3-phase system. In a 3-phase system the line voltage is usually quoted as the nominal voltage, and that is the voltage between any two of the live wires. The voltage between one of the lines and neutral is 1/sqrt(3) times less.
The green and yellow is the earth wire The brown is the live wire The blue is the neutral wire A poem to help is: The brown live cow drinks from the blue neutral water and eats the green grass from earth