Depending on who is asking about, it could be. But strictly speaking, no. When referring to "load", this could be resistance and reactance (Load at a certain power factor).
Load current is related to load resistance by an inverse relationship. The load current increases linearly as load resistance decreases. Remember, the less resistance, the more current.
when source resistance and load resistance are equal maximum power is transfered
Because by increasing the load resistance, the total circuit resistance is reduced. This means with less resistance, there is more current drawn from the source. Doubling the size of a load resistor increases the load current.
explain why all the load must be removed when to conduct the insulation and resistance testing
The dc load resistance is Rc but the AC Load resistance is (RcRl). If a load line is drawn the slope of which is -1(Rc Rl) . Then it is called an AC load line and it is to be used when the transistor is operating as an amplifier.
Load current is related to load resistance by an inverse relationship. The load current increases linearly as load resistance decreases. Remember, the less resistance, the more current.
No. Load resistance is the value of the element actually doing the work of the circuit it is connected to. A speaker connected to an amplifier is the load.
when source resistance and load resistance are equal maximum power is transfered
The resistance arm is the side of the lever (from the fulcrum to the load) that carries the load.
Because by increasing the load resistance, the total circuit resistance is reduced. This means with less resistance, there is more current drawn from the source. Doubling the size of a load resistor increases the load current.
specification of inductive load,capactive load,resistive load in laboratory
According to ohms law (R=V/I) if voltage increases the resistance also increases .For example: If voltage (V) becomes 2 times the resistance (R) also increases becomes 2 times keeping the current (I) same
The total resistance of a circuit is the sum of the supply's internal resistance and its load resistance, because they are in series with each other. This is true regardless of the magnitude of, or the variation in, the current.
a resistive load is the same all the time, a tungsten load has an initial surge of current that's higher until the filament heats up and it's resistance increases.
explain why all the load must be removed when to conduct the insulation and resistance testing
The dc load resistance is Rc but the AC Load resistance is (RcRl). If a load line is drawn the slope of which is -1(Rc Rl) . Then it is called an AC load line and it is to be used when the transistor is operating as an amplifier.
50