== == Yes. Flat to flat is the correct measurement to take to determine which size of driver (Allen wrench, hex key, etc.) you have.
Depends on what type of caliper you have. They will either be Teves or akebono, if they are teves it is 18mm and akebono im not sure i think 13mm. However both will require a 7mm Allen wrench as well.
i figured it out if any body else has this problem its a size 12 i figured it out if any body else has this problem its a size 12
13mm or 14mm
The size of a Violin is measured by the size of the body only. A 4/4 ("Full Size") Violin tends to have a body size of around 14 inches. As violin sizes are non-standardized, this size will vary depending on who made the violin, when it was made and where.
My girlfriend has a 2006 escape and I ran into the same problem trying to change her brakes and none of the Allen wrenches fitting. The '06 needed a 9 mm Allen, so I'm assuming the 05 would need the same?! Good Luck! ---------------------------------- I have a 2006 Tribute, 4wd, discs on front and back. I just did the brakes today. Front calipers are 9mm, back ones are 7mm.
7mm Allen wrench
There is no Allen wrench, I believe it is 14 mm open wrench.
9mm Allen wrench
3/8 inch Allen wrench.
You need 3/8 Allen key.
it is a 6mm allen wrench. A ball type allen works best to get to the plug.
I believe it's 17 mm wrench, not Allen key.
You need a 3/8 Allen Wrench
It is not Allen . It is a 14 mm open wrench
Most likely a 15mm wrench. Unlikely to be Allen in that vehicle.
That is a 3/8 Allen.
7mm Allen