For Example: On a 2004 Mini Cooper S -
After a brake service/repair has been properly completed (including replacement with a NEW wear sensor)
The brake wear indicator light on the instrument panel can be re- set (turned off) by:
1)car in NEUTRAL and the parking brake OFF
2)WITHOUT STARTING THE ENGINE
2)Turn the key ignition to position 2 while holding down the brake petal.
The light (if by magic) will turn off (after about 15-20 seconds).
If it does not - continue to hold down the brake pedal until the light does go turn off. It may take a little longer.
how to reset the brake service indicator on mini cooper s 2011
replace front brake pads
There is not a reset for the break wear indicator light on the Mercedes-Benz GL450. You will need to fix the problem before the light will go off.
If you mean the Flat tire indicator button, it's next to the parking brake.
Service it ;)
The brake wear indicator is a non-reusable sensor that is installed in the brake pad. If this sensor is activated then the entire sensor must be replaced. Parts are available on-line if you are not close to a MINI dealership. After the worn sensor is replaced, you turn the key to position II without starting the car and wait for the light to reset. The sensor can be replaced without removing the caliper.
The light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
Press the brake
The ABS indicator stands for the Automatic Brake System indicator. It can be reset by restarting the entire control display.
its quite simple to reset this light (turn on ignition,press foot brake and accelerator at the same time until the light starts flashing then turn off ignition and it should be reset.
How do you reset dashboard brake light on vw passat
get a OBD2 (On Board Diagnostics) reader and reset the code.