Answers.com > Wiki Answers > Categories > Cars & Vehicles > Asian Cars > Toyota > Toyota Camry > Remote door lock works but the door lock button does not?

Remote door lock works but the door lock button does not?

In: Toyota Camry [Edit categories]

Answer:

If the remote locks the door properly that tells me that the wiring and the lock solenoids are operating OK. I'm also taking it for granted that the switch you spoke of is the door lock switch on the drivers door. Does the passenger door switch work properly? If so, then you probably have a bad switch on the drivers door.
(IMPROVE) You can remove the door lock mechanism from the panel and gently pry open. Carbon build-up is common on the switches. Use a pencil eraser to remove the carbon and ensure the switch functions properly. Re-assemble.

First answer by Markavet. Last edit by Allcitylocksmith. Contributor trust: 3 [recommend contributor ]. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these Toyota Camry questions?

	What kind of oil filter does the Toyota Camry use?	Answer it!
	How do you reset the Toyota Camry?	Answer it!
	Is seal married?	Answer it!
	How CNG conversion kit works?	Answer it!

Relevant answers:

Why doesn't my remote door lock work?
It could either be the battery inside the remote.... which I'm sure you've tried. Or your sensor inside your car could have gone bad. Depending on what kind of car you have, it could turn out to be...
How does a relay door lock work?
Do you: Want to know how they work? Want to know how to test? Want to know how to replace? What kind of vehicle is it in? What are the symptoms? Your question is too vague.
My automatic door locks do not work. Why?
Do they work when buttons are pushed? If so, perhaps need to be re-programmed. If not, check fuses, If good perhaps actuators are bad (but hard to believe all are bad)Perhaps a bad relay?
What causes door locks not to work?
ANYTHING could happen to make it not work.
What would cause 2000 Dodge Dakota power windows and door locks to not work with door buttons?
When I opened the door panel to make voltage and continuity checks on the main wiring cable I found the plug that goes to the master switch panel unplugged. I replaced the plug and all worked well....