Correction:
The bolts to remove the brackets are not visible through the slots in the bumper, the turn signal housings must be removed from the bumper first. Use Phillips screwdriver to remove one screw per side to remove the turn signal housings. Then use a long extension and a 12 MM socket for the bracket bolts, through the signal housing openings. Two bolts per side, one nut per side. The nuts are located one each side, on the back side of the radiator support.
Additional Help:
I just did this today. The original poster is correct in the 4 bolts and 2 nuts to remove. However, there are a few additional nuts/screws to remove to fully remove bumper. First, there are 2 screws on the bumper on the inside of the wheel well, 2 on each side, 4 total. Follow the bumper down to the bottom and then move forward from the wheel about 6 inches. You'll see another bolt. Again, 1 on each side, 2 total. Lastly, there are 2 nylon screws that connect the lower bumper cowl to the forward engine cowl. To remove unscrew halfway and then pull. It takes a pretty good tug, but it will come out. The bumper should now be free to remove.
If you're just changing a headlight, I would recommend removing the 4 bolts and 2 nuts the original poster mentioned and then the additional hardware on just 1 side. You don't need to fully remove the bumper to get the headlight out...just need to really pull it away and down. Removing all hardware on only one side will allow you to pull it down on just one side and remove the headlight. This also makes reassembly much easier. Good luck!
yes
Front? Rear?
This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
It is about $300 to $350 in Flushing NY
Not 100% but it should fit yes the accord 5 gen was from 94-97
This normally requires removing the front bumper and the side quarter panel. Not an easy task if you aren't mechanically enclined.
High tone under bumper on driver side...low tone under bumper on passenger side...front bumper.
left front of bumper and filler is left front of engine bay. Marcus. L
Nope, and you should probably use craig's list instead...
1st take off the screws then he old bumper...put the new one in and the return all the screws. EASY!!!
remove the square pop-out on the bumper and there is a screw on the outside of the light
You must remove the wheel/tire in order to remove the front strut.