Turn the key to "run"
pump the accelerate pedal 3 times within 5 seconds
wait 5 seconds
light should flash - meaning it is resetting the opil light
cycle the key off then on, you're good to go
If you reset oil life without changing the oil you will throw it off schedule.
If your truck has the DIC (Driver information Center) Make sure the truck is in PARK. Change to the display "Oil Life Remaining" Press and hold the SET/RESET button on the DIC for 5 seconds. If you don't have the DIC the make sure the truck is in PARK and press the trip odometer reset stem for MORE THAN 5 SECONDS. The oil life will change to 100%.
Reset vw beattle
What is the engine and front differential oil capacities for a 2008 Chev. Duramax engine? 2008 gmc savana with duramax engine
I would say the average grade of oil used in a Duramax is 15W40
press the setup button until it switches to life, then press reset, if the oil life is already up press reset first then press setup until it switches to oil life, then reset again
Your truck will do this at a set milage just like your oil change message. To reset your oil change message with the key forward (not running) hit your gas 5 times (it may be 6) and a message will appear "oil life reset". To reset you fuel filter life with the key forward (not running) hold your gas and brake for 10 seconds or until the message comes up saying fuel filter life reset. But remember only do this if you accualy did change your filter. The other message your can get is water in fuel. This there is no reset. You have to reach under the fuel filter and crack the drain loose but it's usally better to just change the filter.
The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL message being turned on, reset the system. Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the CHANGE OIL message, do the following: 1. Press reset stem till it Displays "OIL LIFE" on the DIC.(3 times) 2. Press and hold the reset stem. The oil life will change to 100% and a beep will sound. 3. Turn the key to LOCK. If the CHANGE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure. Hope This Helps.
Press the fuel button until engine oil life appears on screen. Press and hold select button for five seconds. Oil life reset will appear on screen for 10 seconds. The system is then reset.
select oil life on the MID then press and hold reset for 10 seconds and oil life will reset to 100%. this is in owner's manual.
15w40
The drain plug for the engine oil on a duramax should be on the back of the oil pan at the very bottom.