0
Should there be enough water in a front loading washing machine so that you can see a visible level of water?
Wiki User
∙ 16y ago
Yes, you may not see it across the door but as it moves you will see it splash.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why does the agitator barely move in a washing machine?
An agitator that barely moves in a washing machine likely has too many clothes in the machine. Too many clothes constricts the agitator and prevents it from working as it should.
How do you fix a whirlpool washing machine that is not spinning?
You should call an repairman +97145864033 Or visit website for best washing machine repair service near me
Are front load dryers more energy efficient than top load dryers?
No. It should not increase the energy efficiency by being a top loading machine compared to a front loading machine. Shop around for the type appropriate to your situation and financial capabilities.
What is the meaning of Fuzzy in a washing machine?
Fuzzy logic is a term that is used in some of the modern washing machines. These machines have sensors that can detect the amount of clothes, how dirty they are and what temperature they should be washed at and adjusts the controls accordingly.
Should a top load washing machine drum wobble back and forth at rest?
This is normal for most washing machine designs. The reason is to enable access to spring attachments which allow the barrel/drum to move during cycles when machine is operating. If there was no 'wobble' the building housing your laundry machines would shake apart with the centrifugal forces created.
How much clothing should you put in a laundromat front-loading washing machine?
Loosely place the clothes into the machine until it's full. Do not compress them. This allows them to move freely, and wash properly.
What do you do if your front loading washing machine says Controls Locked?
Well it really depends on the type of washing machine you have, but for most washing machines you should turn it off then wait about a minute and see if it is working and doesn't say controls locked if it still says that I would contact the store that you bought it from and ask for costomer help.
How long does one washing machine cycle take?
if it is a regular washing machine it should take at least 30 minutes
How do you get a cat out from a wall a washing machine and a sink?
From a wall, pull it out, or chip away at the wall. From a washing machine, put the washing machine on, and pull out the cat, it should be clean by now. A sink, pull it out.
Machine loading chart?
it's the determination of which machine is idle or should perform certain tasks.
How do you get the money from a washing machine?
If you are authorized to remove the money from a washing machine, you should have been given a key to open the money compartment.
Should you buy extended guarantee for washing machine?
no
When should a washing machine be replaced?
A washing machine should be serviced if it is making loud noises frequently, or is vibrating more than usual. The average life expectancy of a washing machine is 11 years, so machines older than that which seem to not be working well should be replaced.
Does washing machine use less or more water than hand washing?
If you run the washing machine only when it is full, then it should use less water than washing it by hand. If you run the washing machine for one or two garments- you will be using more water than if washing it by hand.
Why should you connect your washing machine wire to a metal rod that is driven into the ground?
To ground it. Washing machine build up a lot of static electricity.
Should a front loading washing machine repeatedly agitate for a few seconds and then pause for a few seconds throughout the washing cycle instead of agitating continuously?
It depends on the model. I really don't know how many do and how many do not. Every one I've worked with in my positions as laundry attendant have done it.
How do you take apart hotpoint washing machine?
A Hotpoint washing machine should come with an instruction manual showing how it is constructed. By looking at the construction diagrams of the parts it can be known how to take apart the machine.
