Want this question answered?
The channel that NESN is on with Time Warner Cable will vary depending on location. You can access the channel guide on the remote control by pushing the guide button.
If you have Time Warner Cable, DirecTV or dish, grab your remote and hit the Guide button. That will give you a list of the channel line up and from there you can find History.
One can find the RTE TV Guide directly on their website or by using the tv guide channel button on their remote control. Another source would be to ask your tv provider.
One can find the programming guide for Sky televisions channels via the services button on the remote control and will give a step by step guide of you can visit channel 950.
what year was the remote control invented?
Hold down the Xbox guide button on it. Or- Hold down the PS button on it. Or- press a button on the Wii Remote connected to it.
InstructionsAutomatic Code Search1 Turn on the first device you want to program to the Gemstar remote control.2 Hold down the button you want to program, for example "DVD," while holding the "ON/OFF" button until the red indicator light comes on. The remote control is now in programming mode.3 Point the Gemstar remote control at the device and press the "Play" button. The indicator light will blink for approximately five seconds as it searches the first group of codes.4 Press the "Play" button after the indicator light stops blinking to check the first group of codes. Continue doing this until the device powers down.5 Push the "Reverse" button and wait approximately 2 seconds. Continue doing this until the device turns on again.6 Save the code setting by pressing and holding the "Stop" button until the indicator light stops blinking.7 Repeat Steps 1 to 6 for each device you want to program to the Gemstar remote control.Direct Code Input8 Review the last page of the RCA Gemstar remote control user manual. This page has a list of device manufacturers. Look up your device's manufacturer to find the remote codes for your device.9 Turn on the device you want to program to the remote control.10 Press and hold the button you want to program, such as "SAT/CABLE," and use the keypad on the remote control to enter the first code from the list.11 Release the button you want to program and press the "ON/OFF" button to see if the programmed code worked. The device should shut off if the code was successful.12 Repeat Steps 3 and 4 with the next code on the list until you find a code that operates the device.13 Program the rest of the devices you want controlled by the Gemstar universal remote control by repeating Steps 1 to 5.
You should press the red button on your Sky remote, and it will guide you from there.Hope this helps
RDP. Remote Desktop Protocol (RDP) is used by the Windows Remote Desktop and Remote Assistance utilities to connect to and control a remote computer. Remote Desktop and Remote Assistance listen at port 3389.
For DISH Network, you can bring up your program guide by pressing the Guide button on the right of the DISH remote. The lower numbers on the guide will be your local numbers. Local channels can start at 2 to 71; just look for CBS on the guide.
I used code 3202 into the CBL button and it works fairly well but no guide.
One can get a satellite dish TV guide by visiting their official website and on the site you will find the TV guide to all channels. One can also subscribe to TV guide in order to receive the schedule of all shows.