pin in flywheel down right hand side front of block then fit camshaft pin or 8mm bolt ,then fit 8mm bolt in pump pulley these are the timings marks
http://www.justanswer.com/questions/2d6n5-set-timing-marks-nissan-qg-9
http://www.justanswer.com/questions/2d6n5-set-timing-marks-Nissan-qg-9
nead reinstall chain timing of Nissan pulsar N 15
what do you mean timing specs. your question is a little vague. are you talking about cam specs or ignition timing. the cam you line up the marks on the gear to the head and the ignition timing is about 15 degrees before top dead center
red mark is TDC. 15 degrees BTDC where you want to be is 3 marks after TDC.
Both the crank and cam sprockets have timing marks on the sprocket and on the engine. As you face the front of the engine, with the sprockets in front of you, the cam timing mark is approx. 85 degrees right of top center. The crank mark is approx. 10-15 degrees right of top center (piston #1 should be top dead center). Line marks on sprockets with timing marks on block (tin), slip on belt and tighten tensioner. Manually rotate engine 2 complete revolutions and check that both marks are still aligned.
looking at the timing marks from the top left to right you have 5 degrees after top dead center, then top dead center then 5 degres 10, 15 then 20 befor top dead center. the timing is 7 degrees before top dead center
The 1997 QX4 has 5 equally spaced markings on the Crankshaft Pully. The most left marking is TDC. Then the next marks to the right are 5, 10, 15 and 20 BTDC. The correct timing for this model vehicle is 15 Degrees BTDC. To the best of my recollection you are permitted +/- 2 Degrees. I read one source that said the vehicle should be in N.
There is one on the timing belt plastic cover and it's a scale from 0 to 15, another park is on the engine body behind the camshaft pulley. The hole in the camshaft pulley must align with the mark on the engine body and zero on the timing belt plastic cover.
Leo Marks died on 2001-01-15.
I'm not sure if its the same but my 86 3.8 is set at 15 deg. OTDC try a chilton's manual it should tell you
Upto 15 grace marks in Maharashtra state board.