Oh my...I just happened to me 6 times in the last 6 months...same vechicle. My van is getting fixed for the 6th time@##0# 1998 with 124K perfect condition...well Ok not quite perfect but pretty close. This time the dealer might??? have found the answer. There is a short in the instrument panel.,it was drawing 9 volts instread of the normal 2 volts. I have spent around 6k in the last 6 months and abount to spend 1k more. It is time to trade this puppy in for a Toyota or Honda!!!!!
solenoids are what clicks, yes it will click if the battery is low.
assuming the battery and cables are good and connected....check the ignition switch..:)
replace your starter assembly
WHAT DOES THE CAR DO WHEN YOU TRY TO START IT? NOTHING? JUST CRANKS? CLICKS,FAST/SINGLE?
If you hear the starter spinning but not turnover it over. Or if the starter just clicks when you try to turn it over. If anything you can just take it out and have your local auto parts store test it.
If the relay clicks, chances are that it is your motor. Same thing happened to me and we made sure all power connections were good and fluid was good. Nothing happened until we tapped on the motor with a wrench, then the blade came up. Old motors tend to wear out and get "sticky" after a while.
It is important to know what is causing problems in a car. When the horn relay clicks, but the horn does not sound, it is not a fuse but more likely to be the cars clock spring.
If it clicks and doesn't do anything else.. Change the selinoid....its nothing else but that..i just had the same thing like 3 weeks ago....
Likely that your starting motor needs to be reconditioned/re-built
dead battery
if the started doesnt do anything its the solenoid if it just clicks and spins its the bendix
nothing it could just be the tail lights coming on.
Check for bad connections or fusable link
If the cap just clicks when trying to remove you will need to pry the top of the cap off and then remove the botom half with pliers.
What will happen if Sam goes to the View menu, clicks Toolbars, and then clicks Picture?.
There is no function of right clicks in yoville so it wont let anybody do it as its useless.
Many wiper blades on a 1998 Grand Voyager are held in by a clip. Push the clip towards the arm, and then push the blade back. When the wiper blade is free from the hook, disconnect it from the arm by pushing the wiper down the arm a few inches. It will be free and easy to remove. Now remove the old wiper, and prepare the new wiper. Aim the hook towards the new wiper, it will go over the top. Push the blade towards the end of the arm, until it clicks. Once it clicks, it is in the correct position.