0
There are 2 screws marked L and H. On newer Poulan saws the screws have a spline head that can't be turned without a special tool. You will need to purchase this special tool to make the adjustments.
Screw both L and H down til they seat and back out 1 1/2 turns. The saw should start in this position.
With throttle at full, turn high screw in until engine runs smooth.
**IMPORTANT***
Run the saw at high speed for 3-5 minutes so that it is fully warmed up. Adjusting the saw while cold may result in an overly lean mixture which will drastically shorten engine life!
With throttle still at full and engine warm, turn high screw in/out until engine runs smooth.
Adjust low speed at idle . If engine bogs when advancing throttle, turn low idle out as needed to eliminate bog.
Run at full throttle and verify the high speed setting. Back out the H screw about 1/8 turn to make sure the mixture is slightly rich.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What are the carburetor adjustments on a poulan 306 a chainsaw?
Start with 1 1/4" turn out on each of the H and L adjustment screws.
Who made sears 358.352110 chainsaw?
Poulan
Sears chainsaw mod 358.356331-what mod poulan chainsaw is this?
That would cross to a poulan 2800. Scott www.chainsawr.com
Craftsman model 358.360171 chainsaw?
CRAFTSMAN POULAN 1800/2000 CHAINSAWCRAFTSMAN POULAN 1800/2000 CHAINSAWa craftsman poulan 1800/2000 chainsaw
Where would one be able to purchase Poulan chainsaw parts?
To purchase Poulan chainsaw parts you can go to Sears Parts Direct, Poulan Pro Spare Parts, Repair Clinic, Jack's Replacement Parts, eBay and Order Tree.
Who makes dayton chainsaw?
Poulan made them for the dayton electric company.
What do you do to adjust a carburetor on a poulan chainsaw?
Unless you are a authorized service mechanic for the Poulan company, you will not be able to do your carburetor adjustment, because the carburetors are being manufactured with a cap on the adjuster screws and there is a special tool needed to do the adjustment, and only a ASM will have this tool . Although i have seen them being sold on other sites. but the reason for the manufacturing of the carburetor this way is from the EPA not wanting a Joe Sschmo adjusting it too high or too low and letting the harmful emissions effect the air.
Where are poulan chainsaw made?
Poulan Pro Chainsaws are built in Ameeica, more specifically, the state of Georgia
What spark plug goes in a poulan pro 18 chainsaw?
Champion RCJ7Y
How old is my Poulan chainsaw?
Since Poulan is still making chainsaws, there is no way to answer your question. If you contact Poulan Customer Service through their website, with the SERIAL NUMBER of your saw, they may be able to tell you.
What is the point gap on a poulan 306 chainsaw?
Should be set at 0.015" to 0.016" gap
What is the proper gas to oil mixture for a Poulan 260 Pro chainsaw?
.025:1, gas to oil
