Answers.com > Wiki Answers > Categories > Technology > What are the Oxygen-acetylene welding equipments?

What are the Oxygen-acetylene welding equipments?

In: Technology, Welding and Cutting [Edit categories]

Answer:

Oxygen tank, Acetylene tank, regulators for each tank, hoses, a torch, and a striker. Check valves are also a good idea if they're not already installed.

First answer by Kmcquiggin. Last edit by Kmcquiggin. Contributor trust: 37 [recommend contributor ]. Question popularity: 2 [recommend question].

[report abuse]

Can you answer these Technology questions?

	Should you buy the barbie nail printer used?	Answer it!
	Does accessory geeks work on the weekends?	Answer it!
	Did somebody try to use the pyramids in a way of creating energy through crystals before plundered?	Answer it!
	How do you start to learn something inspiring why we confused?	Answer it!
	How do you get pressure trance meter calibration?	Answer it!

Relevant answers:

Why for welding use oxygen and acetylene?
Because of all the gas combinations used with this process Oxygen and Acetylene, in correct proportions, produce the highest flame temperature.
What is the general mix of oxygen and acetylene in welding?
A general rule is 3 parts Oxygen to 1 part Acetylene. Other fuel gasses may vary the ratio. This produces a Neutral flame. See the answer to "Types of flames" for more info.
When welding with a 3 tip what should the oxygen and acetylene be set at?
If you set your tanks to about 5 psi and 5psi, you should not have to change the pressure, instead simply adjust the knobs on the torch to give more of each gas. If this still is a problem, try 7-9...
What is the difference between oxygen and acetylene and MIG welding?
Oxy-Acetylene, uses a burning flame to melt the metals being welded. You need a separate filler rod and flux to complete the weld.MIG (Metal Inert Gas), uses electricity in an effective dead short,...
What does oxygen have to do with welding?
Oxygen is an atmospheric gas that is unwanted in almost all welding processes because in it's molten state, metal oxidizes very easily and causes a weak joint. Weld surfaces are protected during the...