Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Chevrolet > Chevy 350 > What are the disadvantages of a bridge rectifier?

What are the disadvantages of a bridge rectifier?

In: Chevy 350, Electronics Engineering, Civil Engineering, Bridges and Tunnels [Edit categories]

Answer:

One segment goes out, you replace the whole thing. They tend to build up a little extra heat since they're all crammed into a single package.
To avoid problems, use a bridge that will only run at half capacity. Meaning, if your device is pulling 1 amp, use a 2 amp bridge.
And USE A HEAT SINK!!! and don't forget the heat sink grease.

First answer by Redbeard. Last edit by Redbeard. Contributor trust: 3551 [recommend contributor ]. Question popularity: 2 [recommend question].

[report abuse]

Can you answer these Chevy 350 questions?

	What size is a GM crate engine casting M10069VP?	Answer it!
	What is gearing up?	Answer it!
	What does the stamped number MJ25800 on your Chevy small block designate?	Answer it!
	What does MJ25800 stamped on your Chevy engine mean?	Answer it!
	What is the bolting torque sequence for a Chevy small block intake manifold?	Answer it!

Relevant answers:

What does a rectifier bridge do?
Imagine a rectifier as a valve that only allows electrical current to flow in one direction. When using a single rectifier you end up with half of the wave cycle being cut off (when the cycle turns...
What are the disadvantages of bridges?
Cost a lot of money to construct and maintain. Some bridges are an eyesore.
What are advantages of bridge rectifier?
because its PIV rating is less than half wave rectifier
What is the difference between full wave bridge rectifier and bridge rectifier?
Those terms are different names for the same thing. When properly connected, a bridge rectifier is always a full-wave rectifier.ANSWER: The difference is that twice the input voltage will be...
What is the use of bridge rectifier?
A bridge rectifier makes use of four diodes in a bridge arrangement to achieve full-wave rectification. This is a widely used configuration, both with individual diodes wired as shown and with single...