 |
What are the timing marks for a 1993 fzr-600 yamana?In: Motorcycles |
[Edit] |
Piston 1&4 have to be at TDC, T- mark on the generator side has to match with the upper and lower block joint. Intake camshaft goes on the carburator side and exhaust on the manifold side. Camshaft caps are named I1,I2 and E1, E2 they have an arrow which should point to the clutch side. E2and I2 goes on the clutch side and i1,E1 on the generator side. !1and e1 have a punch mark which is aligned with thepunch mark at the camshafts 90 degrees vertical from the block where they sit. Install exhaust camshaft with out any slack and the install intake cam, you might need to rotate this second shaft to get it aligned. install chain cover and torque all bolts to 7.2 ft/lbs install tensioner on the side and get a new gasket for the cover. Good luck.
First answer by ID3475568834. Last edit by ID3475568834. Question popularity: 7 [recommend question]
|
Research your answer: |
Answers.com > Wiki Answers > Categories > Cars and Vehicles > Motorcycles > What are the timing marks for a 1993 fzr-600 yamana?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
