According to the Ford shop manual, torque is: 89 lb-in or 10 NM. The sequence is the same for the top and bottom manifold, as follows: The top four bolts are tightened in this sequence: 7-1-3-5 The bottom four in this: 8-4-2-6 Good luck
89LB-IN
what are the torque specs and sequence for a 1992 Nissan maxima manifold
35 ft pounds
Ineed the torque sequence and tightening specs for a 92 GM 3800 intake.
89 in. lbs
The 1997 Mercury Cougar 4.6 liter engine intake manifold torque sequence should begin at each end of the manifold. Keep moving towards the center and alternating from and to end.
Start on the inside do an X pattern and work your way out
just start in the middle and tighten in circler pattern
need to know the torque for f 250 triton intake manifole pardon my spelling
the sequence is the two center bolts on each side, the work your way outwards
Intake bolts should be torqued to 35 ft lbs in the appropriate sequence. There should be 12 total "intake" bolts
what is the torque specs to a 2002 Chevrolet Malibu 3.1 liter motor. Need head and intake torque specs. and sequence.