According to the manual for a EJ25 SOHC:
Bolt sequence:
____
| C A F |
| E B D |
-----
B: INSTALLATION
1) Install the cylinder head and gaskets on cylinder block.
CAUTION:
• Replace cylinder head gaskets with new ones.
• Be careful not to scratch the mating surface of cylinder block and cylinder head.
2) Tighten the cylinder head bolts.
(1) Apply a coat of engine oil to the washers and bolt threads.
(2) Tighten all bolts to 29 N·m (3.0 kgf-m, 22 ftlb) in alphabetical sequence.
(3) Tighten all bolts to 69 N·m (7.0 kgf-m, 51 ftlb) in alphabetical sequence.
(4) Back off all bolts in reverse order of assembly by 180° first; back them off by 180° again.
(5) Tighten bolts A and B to 34 Nm and bolts C-D-E-F to 15 Nm
(6) Tighten all bolts by 90°
(7) Tighten all bolts a further 90°
CAUTION:
Do not tighten bolts more than 90° in total angle
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
The 2005 Yamaha cylinder bolt torque specifications are 90 pounds per square inch. The cylinder bolts should be torqued at 30 pound intervals.
torque specifications
36 ft lbs and then 90 degrees
The torque specifications for the cylinder had, in your 2003 Kia 1.6 liter engine, is 120 pounds per square inch. The bolts should be torqued at 40 pound intervals.
58 ft lb inner to outer clockwise staging...
Torque specs for a 1995 subaru impreza 2.2 head bolts?
The Chevrolet 2.2 liter engine had bolt torque specification is 120 pounds. The head bolts should be torqued in 40 pound intervals.
The torque specifications, for your 2002 Kia cylinder head, is 120 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
torque for 2c engine cylinder head bolts
torque setting for cylinder head bolts for a skoda felicia
Cylinder head bolts torque is 59-64 ft lbs (cold).I suggest rechecking the torque after about 500 miles or later.And always recheck with engine cold(meaning not run for the day).