Most offen its the encoder motor it is a electric motor the engauges the All wheel drive its located to the passager side of the transfer case and can be bought from auto parts store for around 170.00$ Thanks James
You can disconnect the negative battery cable, wait a couple minutes then reconnect the cable. This will clear the codes and reset the check engine light but, if the reason the light came on isn't fixed the light will come back on soon.
After you have fixed the issue that caused your check engine light to come on, you can use a pocket scanner to erase the code, but this causes your computer to reset and during an inspection will cause many unready codes failing the inspection. You must drive your bravada 5 miles at a non-stop 55miles an hour to clear the computer, sometimes it just takes a few days of driving to get the reset to clear all codes but normally the 5 miles at 55mph will do the trick.
the driveshafts come out of any vehicle, because they're spline fitment, they should be held in by the suspension/steering components though
It will, if it causes the fuel mixture to be out of range.
Have vehicle scanned to see if any codes are stored to determine the problem
what causes the battery light to on a 2005 ford expedition to come on?
The Trac Off light will come on if you push the traction button located below the automatic gear shifter. If driving and the light comes on, as well as the check engine light, then there is a malfuntion with the system. If low trac comes on, it means just that. You have low traction! Hope this helps :)
Any problem with the car that affects its emissions will cause the light to come on and stay on until the problem has been fixed. (There are literally dozens of possible causes.)
usually a bad wheel sensor.
motion of anything
Use a code reader to find out why the check engine light is on.
pooop