0
What causes a car to idle at high rpms when you put it in park?
Wiki User
∙ 16y ago
either the throttle position sensor (TPS), or a vaccum leak
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How high can a 289 engine idle be?
It should idle at aprox 650 rpms warmed up.
What is the idle speed for ford bronco 5.8?
Roughly 800 RPMS while in park and roughly 600 RPMS while in drive or reverse
1968 car idle very high when started in park?
Your car will idle high until the engine begins to warm. You could set the idle to be a bit lower, but that may cause the engine to stall out when it's cold out. The engine should begin to lower the RPMs when it is warmed up.
What does a 55 Chevy 235 inline 6 idle at in park and in gear?
900rpm, and 600 rpms, respectively.
If the transmission is in need of service will it cause the car to idle and run rough at low rpms yet run smooth at high rpms?
no
High idle issue on 2000 grandam 2.4 TC On startup it will idle at 2600 rpms and lower slightly to around 1400rpm's?
Could be your idle valve
92 Toyota Corolla the Idle speed suddenly jumped from 1000 to 2500 rpms when put into park you adjusted the idle screw as much as possible. got it to 1800 rpms. What else can be done?
Check the timing and check that the cable to the accelerator is adjusted correctly.
When my 98 eclipse is idle my rpms are too high and I cant get it to go to normal?
maybe a vacuum leak
What should a 1971 skylark be idling at in park?
it sould idle like any other car around 700 or 800 rpms.
Harley Davidson 88 cubic inch oil pressure how much it should be?
Obviously depends on RPMs. Normally 15-20psi at idle. Could be as high as 30-40psi when the engine is under high RPMs.
Whats the problem when a 91 camaro rs 350 reaches 80 RPM while in park?
hopefully by 80 u mean 8000 rpms i'd say ur idle is set too high because the car won't idle at 80 rpms once it goes below a certain point it cuts out so i'd say find a way to loosen the throttle cable
Why does your 99 Saturn always idle at 3000 RPMs?
You have a vacum leak. A big one. Check all your hoses. Idle should be under 1k rpms
