'Can' yes. 'Should' no. <<>> Never use a green wire for a neutral. It is colour coded for a reason and that is to protect the people that work on electrical equipment. If you turn a ground wire into a neutral it then becomes a current carrying conductor. There are times in the electrical trade when grounds have to be disconnected and if it is used as a neutral and the tradesman is holding one end and touching a grounded object a shock will occur. Again never use a green ground wire as a neutral.
You need to look at the regulations that apply in your country. If in doubt, use a neutral wire of the same size as the live wire or wires.
In North America, the neutral wire is usually white; hot wires will be red or black; ground wires will be green. But it is not always the same; if you are working with three-phase power, or in applications where you have a lot of different wires, color codes can get lost.In USA, Canada and other countries using a similar 60 Hz system:the Neutral wire is colored White or Commercial Graythe Ground wire is colored Green or is bare wireIn Europe and other world areas using a similar 50 Hz system:the Neutral wire is colored Bluethe Earth wire is colored Green and Yellow
Some older wire does not have a ground. All you can do in that case is use a jumper wire to connect the ground to the neutral.
No !
Use the 4 wire if possible. You would only use a 3 wire for an old appliance.You shouldn't if possible. The 3 wire has no neutral wire as the 4 wire does. Som applications require the use of a 3 wire and some don't.
Copper wire would not be suitable for use in fame tests due to the fact it would cause the flame to change colour (usually to green). The experimenter wants to observe the colour change produced by the sample, not the wire.
what colour is the wire i use to hock up a tach on a 1989 Chevy 350
The type of wire you are looking for is called lamp cord. It comes in different colours usually to match the fixture. Fixtures hanging from chains use a clear insulation so as to blend in with the fixture chain colour. Remember that the smooth wire of the lamp cord connects to the hot wire and the ribbed wire on the lamp cord connects to the neutral wire in the ceiling junction box.
All devices use two wire, the live and the neutral. These carry the current used by the device. Most devices also have an earth wire for safety, which carries no current until a fault occurs and then the fault current in the earth wire might save someone from being electrocuted.
The raised rib is only found on lamp cord wire. Other flexible cords will have the wire colours identified by the colour of the wires insulation. In these types of flexible cords any connections to devices shall be made as, white to the silver coloured screw, black to the brass coloured screw and green to the green coloured screw.
4 wire household wiring is black, red, (hot wires) white (neutral) and bare or green (ground wire). You say 3 wires. Is it 120v or 240v. If its 240v which is more common just use the two hots and the ground and cap off the neutral wire.