0
What could be wrong if you replaced an existing ceiling fan with a fan with a light attachment and the fan and remote control work but the light does not although it is wired correctly?
Wiki User
∙ 17y ago
Are you sure the light bulb is good? Perhaps it's not wired correctly even though you think it is, or maybe it's a bad light socket/connection, or a bad switch.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
the mode in which the existing text is replaced with the text being typed?
Existing text is replaced with the text being typed in the "Overwrite" mode. (As opposed to the insert mode)
Which correctly completes in the graphic about the article of confederation?
It was replaced by the U.S. Constitution
What to do when the stereo will not come on after the battery was replaced?
The batteries may not be in correctly.
When an existing contract is replaced with an entirely new contract it is called?
NOVATION
Does it take time for the air get colder if you have replaced the air compressor?
If the work was done correctly, no.
Why was Luge replaced for the skeleton in the Olympic Games?
Although they share a track, luge was not replaced by skeleton.
Does an exhaust manifold get worse if it does not get replaced?
If there is existing problems yes it can and most likely will become worse!
Will a heavy van be as good as new when the frame is replaced due to damage?
If it is done correctly, yes.
How do you replace a starter for a 1990 Buick Regal Gran Sport?
There are several wires that must be removed from the existing starter before it can be replaced. The wires need to be taped and labeled so that they can be put correctly back on the new starter. The old starter needs two bolts to be taken out to put the starter in.
Is it true or false that an existing asset should not be replaced until its original cost has been fully recovered?
true
True or false An existing asset should not be replaced until its original cost has been fully recovered?
False
Why does my 2001 Jeep Wrangler run out of gas at a quarter of a tank?
This is usually caused by either the sender in the tank is bad and should be replaced, or the gauge is not reading correctly and needs to be repaired or replaced.
