0
What could cause your high beams not to work on a 1993 Corsica?
Wiki User
∙ 12y ago
my hi/lo switch just crapped and the lights died completely before the switch quit for good. Maybe that's what happened to you? If anyone knows how to change the switch on a 1990 3.1L Corsica please post.
Thanks
Freaker
I had same problem on 89 Corsica. Hi/lo switch under dash and hard to take off unless you remove steering column so I unplugged switch and plugged in new switch and set new switch on low beam and wired switch to column. Now have low beams but since new switch not connected to activator rod (which goes to turn signal handle) as old switch still attached to activator rod, only have low beams. New switch about ten dollars. On 89 there is ground wire on body in front of battery. First, unbolt and clean ground, as bad ground can make lights inoperative so if you are lucky, cleaning ground could solve problem.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you turn on high beams in a 1993 Corsica?
they had to use ropes
Did not find trunk release button on 1993 Chevy Corsica?
where is the trunk release button for 1993 chevy corsica
How do you remove headrest from 1993 Chevrolet Corsica?
how to remove headrest of 95 chevy corsica without tabs
What transmission is in a 1993 Corsica?
It is a TH125C(3T40) 3 speed.
Will a transmission from a 1993 Chevy Corsica fit a 1996 Chevy Corsica?
Ask the same question at batauto.com in the forum for transmissions. Koug
How fast can a 1993 Chevy Corsica go before the governor kicks in?
A 1993 Chevy Corsica can only reach 111 MPH before the factory governor will be applied....this is with the 2.2 Liter engine
Where is the fuel pump relay switch on a 1993 Chevy Corsica?
in the trunk
Does the car need to be on when you check the transmission fluid in a 1993 corsica?
yes
Does the computer have to be reset after disconnecting the battery on a 1993 Corsica with a 3.1 engine?
NO
Why do you have High Beams Lights But No Low Beams Lights on my 1993 Chevy Van?
Bad bulbs Bad dimmer switch
Where is the distributor for a Corsica 1993?
there is no distributor. it uses coil packs and control modules
How do you install a starter on a 1993 Chevy Corsica?
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
