Typically, no.
If you have alage and are using an algaecide to help clear the water, then the chlorine is also being used up killing alage and the decaying dead algae cells in the water.
If you don't have algae and are using an alagecide as a preventative measure, then the algaecide will slowly breakdown on its own. But it will not use up the chlorine.
Hope this helps ...
check the cyanaric acid level of the water, you may have low or no stabelizer in the water, this will mask the chlorine reading. you may have a good level of chlorine but is being masked by lack of stableizer. hope this is of help, enjoy the season.
Ah, yuck. Not a good idea. You may also have E.coli, cryptosporidium, giardia and who knows what in the water. I can only imagine what the quality of the water is or what shape the equipment is in. Booo.
k
I believe that K may have misread the question . There is not too much algae but rather too much algaecide in the pool. I have done some research and found that eye and skin irritation can occur and that swimming is not recommended. The solution is based on the type of algaecide used. If it was copper based than the only answer is to drain or partially drain (I've seen both solutions) and refill the pool. If it is a non-metal based algaecide it will clear up on its own but to give it several days to a week.
Adding too much Algaecide to pool water can result in swimmer's skin becoming irritated. It can also make the water foamy. The best way to correct this problem is to give the Algaecide time to go away on its own. Backwash the filter from time to time to help it along.
Dangerous, It would take a larger amount of chlorine in a pool for it to be considered "dangerous" at least to people and animals. It would cause a person dry skin with extended exposure. Most importantly the chlorine would most likely be more harmful on your pool then it would on a person. Excessive chlorine could cause bleaching of a pool liner, and could start to degrade pool equipment if left go for a period of time.
Ignore it it will go away eventually.
yes
One of the side effects of having too much algaecide in a swimming pool includes the likelihood of nose and eye irritations after prolonged swimming. Dry skin is also common after someone has been swimming the whole day and did not lotion up.
It could be out of balance chemically; it could have a dirty filter or it may have too much algaecide. Have you tested the pH lately.
Vaccum the algaecide and its treated remainder to WASTE. Keep testing until it is ok. It should be fine. You may also call the company who makes the algaecide to get their suggestions. When I had a problem with my pool about three weeks ago, the pool company put a LOT of algaecide in the pool and then I vaccumed it to waste. Now I put just the minimum in each week to prevent algae from growing.
Suppose you could but who would want to. You possibly have added too much algaecide. Have a dirty filter. Have poor chemistry - out of balance chemically. Too many people in pool. Lack of proper filtration.
I suggest you contact the manufacturer of the algaecide and find out from them what would be the bes coarse of action.
By killing the green algae with an algaecide available at your pool shop.
Adding algaecide to the pool when the filter is on should not do any harm in fact it should mix it into the water more quickly
Chlorinate it to the max or shock the pool An get some algaecide into it as wel as well.
Too much algicide. The only thing to do is dilute it with water.
my pool did get milky but cleared up after 48 hours
Use an algaecide and test for phosphates.
You want to have the equipment running while adding any chemicals. You will want to wait about an hour after adding algaecide.