yellow flame needs more air or cleaned orange flame could indicate moisture in the fuel if propane have your tank treated your L.P. dealer should be able to do this also I have seen this when people use hemidfers the orange is burnning of the minerals in the water
its hot!
Yellow flames from a natural gas furnace indicate that the combustion ratio is off and you have too much excess air in the mixture, if the discolored flame is isolated in the burner meaning on only 1 out of 3 or more then the burner/orifice may be out of alignment or there maybe a crack in the exchangers cell.
The gas furnace pilot (flame is lit all the time) is sometimes referred to as a pilot light, but no matter what you call it, its purpose is to serve as a small ignition flame for the gas burner. And when this little flame fails to operate properly or go out, it's one of the most common reasons a gas furnace will fail to operate.
If the furnace is direct ignition, The HSI or spark ignites the flame. A flame sensor passes current through the flame, if current is present the main.
flame sensor
with gas? hence gas furnace? theres a gas pipe that puts the gas into 3-4 tube things tht keep lit by the gas bruhhh
Well like with any flame, the lighter the flame, the higher the temperature of the flame. If the flam is burning Yellow, it is at a higher temperature and is burning more oxygen than an orange flame is. That is your difference other than the color.
Improper gas/air mixture.
The main circuit board in your furnace sends a small ac signal to the flame rod so now you have an ac potential from the body of the furnace to the flame rod, When the flame comes on between the body of the furnace and the rod it rectifies the ac in to dc, The flame actually acts like a diode. When this dc voltage is sensed by the control board it knows there is a flame present and thus keeps the gas valve on. Hope this helps
A blue flame means you are getting a good gas/air mixture. If it is orange or yellow then there is more gas than air and should be adjusted.
Pilot gas is the very small flow/burner used to maintain an ignition flame in a gas appliance. Sometimes called a pilot light, or pilot flame, it's used to ignite the main burner.
The sodium turns the flame bright orange..