0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How mm in 4 mil?
1 mil = 0.0254 millimeters4 mil = 0.1016 millimeters
How do you write out 1.57 mil in standard form?
1,570,000 Unless you are using mil to mean "millimetre" then 1.57 mil = 1.57 mm = 0.00157 m Or you are using mil to mean "millilitre" then 1.57 mil = 1.57 ml = 0.00157 l. Or you are using mil to mean "thousandths of an inch" then 1.57 mil = 0.00157 inch.
How thick is 6 mil?
A "mil" is a 1/1000 of an inch. So 6 mil is equal to 0.006 inches.
Where is 50 mil on the ruler?
Right next to 49 mil.
Is 7 mil thicker than 6 mil?
Yes.
What is A MIL Command Status for motor vehicle?
MIL stands for Maintenance Indication Light. If your vehicle fails inspection due to MIL Command Status, it is due to emission failure.
MIL status is off during diagnostics for volkswagen jetta 2000?
Is the light (check eng.... MIL on whening diag. says no MIL?
Hello failed at the inspection st. and they said there was a code p0507 the mil command status failed and the overall obd system result failed you.1999 honda accord v6?
how many amendments have failed to be accepted by the States?
Does the status bar contain a command?
No .
How should you do if the command line and status bar disappear in GstarCAD?
You can control the visibility of status bar in view>display>status bar; Ctrl+9 controls the visibility of command line
How should you do if the command line and status bar disappear of GstarCAD?
You can control the visibility of status bar in view>display>status bar; Ctrl+9 controls the visibility of command line
What cisco IOS command can be used to verify the interface status?
show interface status
What is bgwoutput command?
This is not a command; more of a status that you have a job in the background that is waiting on output to the primary screen.
What command do you use followed by the name of the service to show the current status of the service?
you use the enable command
What is the best command to use to view the routers interface status and protocol status?
sh int brief
Which command in DOS displays the status of a disk?
You can use "fdisk' or "chkdsk"
Which DOS command displays the status of a disk?
You can use "fdisk' or "chkdsk"
