accepted density is a part of the equation of the percent error... i.e. :
experimental value- accepted value/ accepted value x100% = percent error
The actual density of Oak Wood is about .75 g/cm3.
The density of an electron is its mass divided by its volume. The rest mass of an electron is approximately 9x10-31 kg. The size, however, is much more difficult to determine as an electron is not a rigid ball - instead it is more like a wave, with diffuse edges. An approximate accepted size for an electron is 5 × 10-13 m, giving a it volume of 5x10-37m3. These figures give a density for the electron of approximately 1700 tonnes/m3, a density that is 154 times that of lead
Mass and volume are extensive properties, which are dependent upon the size of the sample. A larger sample will have a greater mass and volume than a smaller sample. Density is an intensive property, which does not depend on the size of the sample. Density is a ratio of mass to volume, which does not vary with the size of the sample. The density of a larger sample will be the same as the density of a smaller sample.
Water's accepted density is 1.00 g/mL at standard temperature and pressure so depending on temperature the 1057 grams of water will occupy just about 1057 mL.
Its density. Density is mass per unit volume.
1g/mL
The actual density of Oak Wood is about .75 g/cm3.
Percent error refers to the percentage difference between a measured value and an accepted value. To calculate the percentage error for density of pennies, the formula is given as: percent error = [(measured value - accepted value) / accepted value] x 100.
The density percentage error is computed through this formula; percentage error equals in the observed value minus the accepted value over accepted value times 100 percent. Density is the quantity of mass of a substance measure per unit of volume through the formula density is equal to the quotient of mass and volume.
Density ------------------------------------------------------------- The density is measured in SI by kilogram/cubic metre (kg/m3). Also g/cm3 is used but is only an "accepted" unit.
the density of balsa wood ranges from 40 to 340 kg/m^3....moreover the typical density is stated as 160kg/m^3...however most people use the debsity as 200kg/m^3 I suppose for calculations purpose
At room temperature, the accepted value f or the density of aluminum is 2.7 g/cm3 (grams per cubic centimeters). Aluminum is a metal with the atomic number of 13.
In science, and most specifically chemistry, the accepted value denotes a value of a substance accepted by almost all scientists and the experimental value denotes the value of a substance's properties found in a localized lab.
percent error = [(experimental value - actual value)/(actual value)] x 100 so in this case: % error = [(68.7-63.50)/(63.5]x100
The density of an electron is its mass divided by its volume. The rest mass of an electron is approximately 9x10-31 kg. The size, however, is much more difficult to determine as an electron is not a rigid ball - instead it is more like a wave, with diffuse edges. An approximate accepted size for an electron is 5 × 10-13 m, giving a it volume of 5x10-37m3. These figures give a density for the electron of approximately 1700 tonnes/m3, a density that is 154 times that of lead
13.0
Various publications give the density of pure water at 15oC between 0.9991026 and 0.999099 grams per cubic centimeter at 1 atmosphere pressure. One of the most commonly accepted values is 0.9991016 g/cm3 with atmospheric pressure at 101325 Pascals.