Using fittings to change centerline of pipe.
what are some pipe fitting abb
Very complicated formula Try seeking out a 2nd year apprentice as the UA has books with these formula's which are seldom used
The fitting allowance is the difference: (pipe end to fitting center measurement) minus (pipe end to end measurement). It is the amount of length the fitting adds to the end of the pipe (to get the center of the turn).
Various fitting degrees
measure the length of the fitting first. Then insert pipe into fitting and mark a line on pipe. measure that bit of pipe. deduct off the length of fitting and half it to give you your x dimension
Adam Fitting goes by Pipe.
You can't. There is no fitting to do this. Galvanized has to be threaded.
To join lengths of pipe and to route it where it needs to go.
Pipe size times 0.707
To calculate the surface area of a pipe fitting, you need to use the formula 3.14 x L x D. The L stands for the length of the pipe and the D is the diameter of the pipe.
Sewer waste
Swansons square