Want this question answered?
7 bags cement
Wall ties hold the brick steady while the mortar dries as well as keeping the wall steady later.
You need: Enough bricks to build the size wall you need Mortar A Mortar tool, looks like a flat spatula Take one brick at a time and lay on mortar on the side you will stick another brick onto. continue that step and build outwards and length wise.
with cement
form_title=Brick Tuckpointing form_header=7133 What would you like to tuckpoint?*= () Parts of a wall/building () Entire wall () Entire building What needs to be repaired?*= [] Cracks in mortar [] Crumbling mortar [] Holes in mortar [] Uneven bricks [] Evidence of water damage [] Need an evaluation What is the material that needs tuckpointing?*= () Brick () Stone
A Brick Tie is a corrigated piece of metal that nails to the outside of the frame wall and goes into the mortar joints of the brick or other masonary material. They hold the brick to the wall so they do not lean out as you work up.
It consist of reinforcement,brick and concrete.Bricks are laid horizontally between the steel bars and concrete mix is inserted in the joints to fill the gap between bricks and for covering the reinforcement.The slab is supported on the wall and the top surface of the slab is plastered with a 2cm thick cement mortar and over that apply two layers of hot bitumen for water proofing.Over the bitumen coat apply one more coat of cement paste of thickness 5 cm.Provide sufficient slope at the top surface for drainage of rainwater.
There's a saying that "a chain is only as strong as its weakest link", and pretty much the same goes for a brick and mortar wall. If the mortar is stronger than the brick, all that would happen if the wall would be put under heavy pressure is that the bricks would crack instead of the mortar. On top of that, cracked mortar is a lot easier to remove & replace than cracked bricks. Ideally you want the mortar to be just a tiny bit weaker than the bricks. You get a wall that's almost at it's max strength, but easy to repair.
Sound would travel faster through one brick than the same amount of concrete based on molecular structure but if a wall were built with brick, mortar would be required, this mortar would slow the sound vibrations and scatter them, while the same size wall made of concrete is solid and would then conduct sound faster than the brick wall.
Depends on what the wall is made of. If it is brick, masonry anchots can be placed in the mortar joints between the bricks. You will need to drill the mortar with a masonry drill bit.
Hi there, I would use a 5-1 ratio of sand to cement and use a good mortar plastisier. Use plastering sand and mix well. Throughly soak the wall first and apply a light coat (scratch coat) Leave this to dry for a while and before it has completely dried, get the final coat on. Too much water on the wall will result poor bond between the Brick masonry and the plaster on account of lack of suction which is the primary mechanism by virtue of which the Cement Plaster will remain in position against the gravitational force.
Cement mortar is used in bricklaying to adhere them to each other.