open cahannel flow and pipe flow
Open channel is always at atmospheric pressure
Pipe flow has pressure either above or below atm
open channel is smething vch flows in an open area
madherchod, bhenchod, teri maa ka lauda
The open channel flow has a free or rather open surface whereas the pipe flow has a closed surface.
Flow process takes place in open system & non-flow process takes place in closed system.
A: There is a relationship one needs the other both can coexists but not each alone.
A: BIG DIFFERENCE emitting is the study of electronics conduction is the study of current flow
current flows as a result of potential difference i.e. in a circuit if there is no voltage difference between two points, no current can flow between those two points. So voltage has to be produced first.
The open channel flow has a free surface whereas the pipe flow has a closed surface.
The open channel flow has a free or rather open surface whereas the pipe flow has a closed surface.
Flow process takes place in open system & non-flow process takes place in closed system.
a closed circuit
In an open circuit, the electrons cannot flow easily because one of the parts in a circuit is not connected, whereas, in a closed circuit all the parts are connected, therefore, the electrons can flow easily. Hope this helps:)
the difference between flow and motion is well flow is like floating and motion is the way you move
if an electric circuit has potential difference. Electricity will flow only if an electrical circuit is closed.
difference between laminar air flow & reverse laminar air flow
they are different because one is open and the other is closed
Closed means just that...not open and unable to allow sodium ions to flow. Inactivated means that they do not respond to the stimulus. They could be open or closed, but do not receive the signal from the messenger. Also refractory.
In an open circuit no cuttent can flow so the switch would have to be in the off position- the switch is open and not completing the circuit. A closed circuit is one where current can flow all the way through, the switch would have to on and therefore closed.
what's the difference between flow chart and structure diagrams and pseudo code