DC Bridge... We use DC supply, Detector is also a DC current detector and we use only resistive components no need for wegner's earthing device balancing time is comparatively less.. where as in AC bridges opposite of above. i.e. AC supply, AC current detector resisitive+ reactive componants need for wagner's earthing device and balancing time is high as we use AC supply..
I assume you are referring to AC & DC Wheatstonebridges. The main differences is the excitation and meter used to measure the imbalance. In DC Wheatstone bridge excitation & meter are DC. In AC Wheatstone bridge excitation & meter are AC. Another difference is DC Wheatstone bridge is always composed of just resistors, whereas an AC Wheatstone bridge may contain capacitors and/or inductors.
The voltage source is different. Initial measured reading settling time in AC bridge is far less compared to DC bridges
The difference AC and DC grounding is that AC is alternate current and DC is direct current. Grounding for both AC and DC is the same.
There is no difference in the cables. The only difference is the type of electrical power being transmitted. AC or DC applications use the same wires.
Converter is AC to DC. Inverter is DC to AC
ac transmits the voltage over long distances. so v use ac in trains
Alternators produce AC, which is rectified by diodes if DC is needed. Dynamos produce DC by using a commutator.
There is no difference between AC AND DC chockes
The difference AC and DC grounding is that AC is alternate current and DC is direct current. Grounding for both AC and DC is the same.
There is no difference in the cables. The only difference is the type of electrical power being transmitted. AC or DC applications use the same wires.
AC rises with respect to time but DC is steady.
magneto is dc
dc ammeter has three connecting pins while ac has four
AC power is made by alternating current and DC does not change.
ac comes directly from the power socket, and DC is battery source. Answer2: The frequency is the difference, AC has frequency f>0 and DC does not f=0.
The voltage source that is applied to them is the difference between AC and DC light bulbs.
You rectify AC voltage through a diode bridge to convert it to DC.
Converter is AC to DC. Inverter is DC to AC
ac hall effect always rises and dc is always in steady state.................