0
There are no polarity on any single speaker. If 2 or more speakers are to be connected, the way they should be connected is in parallel, so that when one membrane is going out, the others does so too. And not going in the wrong direction. That is why most speakers have a red dot on one of the terminals. Just to show their way of how the coil is set up. <><><>
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you a car radio that only two speakers wires a ground an a positive connection?
That would be a mono radio, usually found in older cars. You may connect 2 speakers, in parallel, but you will have no balance control. Simply wire positive to positive, and negative to negative of both speakers.
Which wires are negative and positive to the rear stock speakers for 2006 Chevy Malibu?
Dark blue is positive and light blue negative on right side and brown positive and yellow negative on the left.
In regards to speakers is the gold wire positive and the silver wire negative?
Yes
My home theatre speakers have grey and white wires which is positive and which is negative?
It does not matter, just make sure all the speakers are wired the same. I would make the GREY Negative.
Trying to install Clarion MD stereo for Peugeot 205 What is the colour of negative wiring from in car speakers?
the negative wiring for the speakers is the same colour as the positive but with a black line going down it
What are the colors for positive and negative on the speakers of a 1995 Cavalier?
The voltage in speaker wire is too small to cause harm. Plug the two wires in. If the speakers work the wires are correct. If the speaker doesn't work try them the other way. ANSWER voltage does not cause harm no matter how high. amperage is what causes harm. speakers will work like a light bulb either way. positive to negative or negative to positive. with sub-woofer you can tell if it is right, the sub should pull inward on deep base . I believe cavalier rear speakers are hooked in series positive in one speaker, negative of that speaker to positive of the other speaker, and neg of that speaker back to stereo
How do you use 16 ohm monitor speakers with an 8 ohm powered mixer?
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
Is a positive plus a negative make a positive or a negative?
Positive + Negative = Negative Negative + Negative = Positive Positive + Positive = Positive Negative + Positive = Negative
What is a negative - positive?
Negative * positive = negative Positive * positive = positive Negative * negative = positive
How do you wire stereo speakers?
The new speakers come with un-stripped copper wires..... you need a pair of wire strippers.... i put in kenwood speakers and the size of the wire was 14 somethin. you would need to get a wire diagram for you car/truck to see the colors of the positive and negative wires. then look on the aftermarket speaker box to see which wire is negative and which one is positive.... After you would do all this, just match up negative to negative and positive to positive. simple as that. I'd recommend wire nutting the wires or electrical taping them... but DO NOT put all four wires together. that will mess your speakers' sound up completely. wire nut the positives together and then wire nut the negatives together.
How is dividing integers similar to multiplying integers with the resulting sign?
The rules for the sign (positive or negative) of the result of a multiplication is the same as division. For multiplication: Positive * Positive --> Positive Positive * Negative --> Negative Negative * Positive --> Negative Negative * Negative --> Positive For division: Positive / Positive --> Positive Positive / Negative --> Negative Negative / Positive --> Negative Negative / Negative --> Positive
If a negative is divided by a positive is it negative?
Yes. Negative/negative = positive Postive/Positive = positive Negative/Positive - negative
