answersLogoWhite

0


Best Answer

The best way to clean flue pipes is to check that the connection is clean and remove the flue pipe, use a flue cleaning brush to brush it down in an up and down motion to remove all the build up.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the best way to clean flue pipes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Chemical Engineering

How will you control the temperature of an endothermic reaction in a mixed reactor?

Studies indicate the best way to control the temperature of the endothermic reaction in a mixed reactor is through making adjustments to the coolant temperature. There processes are highly complex.


Can you put a clear epoxy over an oil concrete stain?

First you must pressure wash as best as possible. Next you need to acid wash the concrete. Finally you should be able to neutralize the acid with a vinegar and water solution. Let dry. You should prepare the whole floor this way.


How much liquid should be allowed in the suction line when charging?

absolutely none. there is almost no more sure way to wreck a compressor than allowing liquid into the compressor.


What are the advantages and disadvantages of CNG and LPG gases?

The Advantages of Compressed Natural GasThe Environmentally Clean Advantage Compressed natural gas is the cleanest burning fuel operating today. This means less vehicle maintenance and longer engine life. CNG vehicles produce the fewest emissions of any motor fuel. Dedicated Natural Gas Vehicles (NGV) have little or no emissions during fueling. In gasoline vehicles, fueling emissions account for at least 50% of a vehicle's total hydrocarbon emissions. CNG produces significantly less pollutants than gasoline. Tailpipe emissions from gasoline operated cars release carbon dioxide, which contributes to global warming. This is greatly reduced with natural gas. The Maintenance Advantage Some fleet operators have reduced maintenance costs by as much as 40% by converting their vehicles to CNG. Intervals between tune-ups for natural gas vehicles are extended 30,000 to 50,000 miles. Intervals between oil changes for natural gas vehicles are dramatically extended--anywhere from 10,000 to 25,000 additional miles depending on how the vehicle is used. Natural gas does not react to metals the way gasoline does, so pipes and mufflers last much longer. The Performance Advantage Natural gas gives the same mileage as gasoline in a converted vehicle. Dedicated CNG engines are superior in performance to gasoline engines. CNG has an octane rating of 130 and has a slight efficiency advantage over gasoline. Because CNG is already in a gaseous state, NGVs have superior starting and driveability, even under severe hot and cold weather conditions. NGVs experience less knocking and no vapor locking. The CNG Cost Advantage Natural gas is cheaper per equivalent gallon than gasoline (an average of 15% to 50% less than gasoline)


What is s Indian Standard code for painting of LPG Pipeline?

I don't know what you mean by s Indian, I assume you mean South and by Indian I assume you mean the country of India. Most likely there is no governmental specification for buried LNG line. There are 2 main ways to protect buried pipeline. By coatings or wraps Most major pipeline companies specify nominally 25 mils of an Epoxy classified as a FBE (fusion bonded epoxy) that works in conjunction with cathodic protection. Most pipes installed are shop coated with a powder and baked. Rehabilitation uses a liquid applied 2 component epoxy applied with either a plural component sprayer, cardtrigde sprayer for girth welds and small area (a pneumatic powered big caulk gun), or by hand (Poor quality finish - many holidays). The downside of coatings is that they cannot take temps above 450F depending on brand- but that is mostly applicable to crude. They may also fail earlier then wraps - will still have 50yrs+ if applied right. The upside of coatings - they fail safe - cathodic protection will let you know when the coatings have failed. Wraps are another way to go. Polyolefin, bituminous and others, but these are the most popular. Polyolefin upsides - stays pliable for 50yrs+ - newer technology then bituminous. Drawbacks- Does not work in conjunction with CP. No way to tell if they have failed. That is when you get explosions. Bituminous wraps - asphalt based wraps The upside of bituminous wraps. They are low cost for initial investment. The drawbacks of bituminous wraps. They are not fail safe (see above), they can become brittle in far less then 50yrs. Hope this helps

Related questions

What is the best way to clean out on the inside straight pipes on a custom motorcycle?

The best way to clean out the inside of your custom motorcycle straight pipes is to remove the pipes and use a cleaning solvent and a rag with a long handled brush.


What is the best way to join copper pipes?

soilder


What is the best way to clean a dartboard?

The best way to clean a dartboard is with a cloth and shining polish.


What is the best way to clean a suit?

The best way to clean a suit is to have it professionally dry-cleaned.


Are water purifiers really the best way to have clean water?

The best way to have clean water, is to boil it. Water purifiers are a close second, and although they still clean your water, they are not the best way to have clean water.


What are so called wood burners?

Wood burners, which are usually made from solid steel, are an old way of heating and cooking. It is connected to ventilating pipes that flow into a flue or chimney as part of proper airflow.


What is the best way to keep my pipes from freezing?

There is no single best way to keep pipes from freezing. Insulating (wrapping) pipes is a common method. Leaving the cold water faucet open just enough for a slow drip is another method to prevent freezing.


Best way to clean clothes iron?

The best way to clean clothes is not to get your iron too hot, and use starch.


What is the best way to clean chenille bedspreads?

The best way to clean chenille bedspreads is to soak them before washing them. Another popular way to clean chenille bedspreads is to apply peroxide to them.


What is the best way to clean booths in a restaurant?

Spraying down the booths with a cleaning spray and then wipe them clean with a rag is the best way.


What is the best way to clean a very soiled carpet?

If you have a very soiled carpet the best way to clean it would be a steam cleaner.


Is there a way to clean marks on Nike Zoom Rookies?

Mr. Clean majic eraser is the best way to clean sneakers