A thyristor is another name for an SCR, which stands for Silicon Controlled Rectifier.
Thyristors or SCRs are bi-directional devices used to control the flow of AC current. Once triggered, the device remains "on" until the next wave of current crosses zero after the trigger is removed.
For more information about thyristors or SCRs see the Related link shown below.
A thyristor is an SCR, which stands for silicon controlled rectifier.
A: Not much different except an extra diode is connected internally whereby the gate can control the firing of of the device in both direction while an scr will only conduct one way only
thyristor is an npnp semiconductor device whereas transistor is a pnp or npn semiconductor device.
Essentially an Scr is a solid state switch that will only allow current to flow in one direction. A triac is essentially two scr's in Anti- parallel that allows current to pass in both directions.
A DIAC is simply a diode that breaks down at predictable voltage.A TRIAC is a 3 terminal device that will conduct whether the anode is at a positive or a negative potential, controlled by a gate.Another answerThey are AC versions of the SCR and diode respectively. Do you need more details?
Yes since the SCRs act as the real thyristors
For power control of inductive load.They can be successfully used for resistive load as well.
An SCS has an additional gate - the anode gate. It is physically smaller than an SCR and has smaller leakage and holding currents than an SCR.
== == == ==
triac act as a ac contactor
An SCR is a rectifier and can only conduct in one direction (half wave).A Triac can conduct in both directions (full wave).
Essentially an Scr is a solid state switch that will only allow current to flow in one direction. A triac is essentially two scr's in Anti- parallel that allows current to pass in both directions.
The diac and the triac are used to control the AC lines. The difference is that triac are bigger than diac.
The SCR and TRIAC are essentially controlled diodes.
thyristor can be scr or triac scr is strictly dc a triac is back to back scr's with a common gate two scr's back to back can be gated independently scrs cost less than triacs an scr can be combined with a full wave bridge to make an equivalent to a triac but this gives an additional 1.5V forward voltage drop
A DIAC is simply a diode that breaks down at predictable voltage.A TRIAC is a 3 terminal device that will conduct whether the anode is at a positive or a negative potential, controlled by a gate.Another answerThey are AC versions of the SCR and diode respectively. Do you need more details?
Yes since the SCRs act as the real thyristors
A TRIAC does not have a symmetrical turn-on point in the opposite quadrant. This will introduce a DC bias, which you probably don't want. You can use an SCR, and then add diodes to allow it to operate in the opposite quadrant, or you can use two SCR's. Alternatively, you can use a DIAC in the TRIAC's gate circuit to balance the turn on point.
For power control of inductive load.They can be successfully used for resistive load as well.
Diac