Cam sensor usually senses the position of the timing belt or timing chain gear and tells the computer when #1 cylinder is at top dead center. In other words, when #1 cylinder comes up. Crank sensor tells the computer when to fire the spark plugs in the rest of the cylinders. In other words, as ther crank shaft goes around it tells the computer when each piston comes up so it can fire it's spark plug.
No. The crank sensor reads the crankshaft location and speed. The cam sensor reads the camshaft.
CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.
I would say that they are one and the same.
It's behind one of the camshaft pulleys. Why would a CRANKSHAFT position sensor be behind a CAMSHAFT pulley ??
Crankshaft sensor is on the back of the bell hosing of the transmission and the camshaft sensor is behind of the motor mount on the left under the coil pack
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
CMP-camshaft position sensorCKP-crankshaft position sensorCMP-camshaft position sensorCKP-crankshaft position sensor
The camshaft sensor is the same as the crankshaft sensor it is local on the passenger side of the valve cover . And going down to your crankshaft inside the timing belt cover
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
A Crankshaft sensor is primarily used for speed sensing. It follows the principle of a rotary encoder. Another important function of the Crankshaft sensor is to ensure synchronization of operation between the Crankshaft and Camshaft with the help of Camshaft sensor. The sensing wheel contains a series of equispaced drilled hole or slots. Usually there will be one longer slot or a missing slot which will be used to position the Crankshaft absolutely with respect to the TDC of the first Cylinder. This positioning of the Sensing wheel is compared with the positioning of a similar sensing wheel on the Camshaft to ensure synchronous operation.
Yes, it is inside the distributor.
The crankshaft position sensor must be behind the timing belt cover next to the crankshaft and behind the crankshaft pulley. The camshaft position sensor is again under the timing belt cover next to the camshaft and behind and the camshaft pulley. Is it the same place in 2000 Camry 4Cyl? Do you have pictures of the location? Hard or easy to replace, and what tools do I need? Thanks alot