Reducing energy use is called energy conservation and efficiency is the percentage of energy that is actually used to perform work the rest of energy that is '' lost '' to the surrondings.
it uses different watts
in EEM copper material used is more than the normal motor.the EEM has more efficiency around 95% than the normal motor.
Power generated by hydroelectric means is no different than power produced by any other means. The only way to demonstrate efficiency and conservation of energy is by keeping the lakes above the dams full of water.
efficiencyThe ratio of useful energy to total input energy is called efficiency. It refers to the percentage of the work input that is converted to work output.
vague question. Efficiency in terms of energy = useful energy/total energy x 100 vague question. Efficiency in terms of energy = useful energy/total energy x 100
Cooling energy depends on the efficiency of cooling device used but cooling load depends on many factors such as the volume of the room, comfort band, fabrics used, geographical and climatic properties of location that the room is built. In simple terms, for a room with a specific cooling load different devices can be used. Since, each device has different efficiency, therefore different amounts of cooling energy may be obtained.
Force implies that you waste energy while in conservation you do not waste it.
storing and controlling
Efficiency is a measure of how completely you use energy, whereas conservation is a measure of how little energy is used. For example: A typical light bulb turns 2% of the power input into light, therefore it is 2% efficient. Not turning the light bulb on in the first place uses no power, and therefore conserves electricity.
Di ko alam,May.
nanghihina siya
Efficiency can never be greater than one because it is the ratio between work you got out of the system and the total energy. Because of conservation of energy, the equation ΔE = Q + W reduces to Q + W = 0.
The law of conservation of energy states that the total energy in the universe is a constant and will remain so for example ( x=y+z ). conservation of energy has to do with reducing the amount of energy used through reduced activity and/or increased efficiency in the performance of a particular task.
There is no difference between the two, it's just another way of wording the phrase.
Eric Durand has written: 'Energy efficiency in hospitals and clinics' -- subject(s): Energy conservation, Clinics, Hospitals, Architecture and energy conservation
The efficiency driers use lss energy and put out less exauhst
Efficiency cannot be greater than 100% because efficiency measures energy, and since energy is not made, only transfered (conservation of energy) then we cannot gain energy. Hence the energy out must be at most the energy in. Thus efficiency can be at most 100%
The law of conservation of energy states that the total energy in the universe is a constant and will remain so for example ( x=y+z ). conservation of energy has to do with reducing the amount of energy used through reduced activity and/or increased efficiency in the performance of a particular task.